NOTE #1: This vehicle Requires a Special INTERFACE BYPASS MODULE due to its MULTIPLEXED
IGNITION/ANTI-THEFT SYSTEM, it will Require Part # DB-ALL or XK09, either Module will
Interface with the IGNITION/ANTI-THEFT System, KEYLESS ENTRY and TRUNK Release
with nothing else needed, to order go to the INTERFACE BYPASS MODULE Page on this
website.
NOTE #2: this vehicle uses a 1-Wire Door Locking System that will Require a (-)Negative thru a
1000 Ohm Resistor to LOCK and (-)Negative thru a 250 Ohm Resistor to UNLOCK on
the same wire in the vehicle. Some units may also requires extra Relays (2) of Part
#775 to connect, See DIAGRAMS. OR SEE NOTE #1
NOTE #3: the DRIVERS DOOR is a PURPLE/BLACK (-) Pin 3, the PASSENGER DOOR is a
PURPLE/WHITE (-) Pin 11, the DRIVERS REAR DOOR ia a PURPLE/GRAY (-) Pin 5 and
the PASSENGER REAR DOOR is a PURPLE/YELLOW (-) Pin 6. when connecting to an
ALAMR SYSTEM use all (4) wires and DIODE ISOLATE, See DIAGRAM
|