| NOTE *1 The STARTER 1 wire, requires a (+) POSITIVE thru a 1300 OHM Resistor to Start See DIAGRAM. OR YOU CAN USE THE PKUGM2X TO GET AROUND THE USE OF THE RELAYS AND IS ALSO A KEYLESS BYPASS.
NOTE *2 The BCM (Body Control Module) is located to the LEFT of the STEERING COLUMN.
NOTE *3 The DRIVERS DOOR TRIGGER is a GRAY/BLACK (-) at the DRIVERS DOOR MODULE in the DRIVERS DOOR, BROWN 16-Pin Plug, Pin 13, the PASSENGER DOOR TRIGER is a BLACK/WHITE (-) at the PASSENGER DOOR MODULE in the PASSENGER DOOR, BROWN 16-Pin Plug, Pin 13. The DRIVERS REAR DOOR TRIGGER is a LIGHT BLUE/BLACK (-) PINK Plug, Pin 15 and the PASSENGER REAR DOOR TRIGGER is a LIGHT GREEN/BLACK (-) PINK Plug, Pin 14 both wires are located in the PINK Plug on the BCM, when connecting to an ALARM SYSTEM use all (4) FOUR wires and DIODE ISOLATE, See DIAGRAM.
NOTE *4 TEST these wires while OPENING the LIFTGLASS and LIFTGATE from the HANDLE on the REAR HATCH of the vehicle.
NOTE *5 THIS VEHICLES REQUIRES A XK01 GMDL6X 4.00 FIRMWARE FOR KEYLESS ENTRY.
|