Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2007 - 2008 Mazda Mazda 6 . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
PART
COLOR
LOCATION
12 VOLT CONSTANT
BLACK (+) AND BLACK/YELLOW (+)
IGNITION SWITCH HARNESS
STARTER
BLACK/BLUE (+)
IGNITION SWITCH HARNESS
STARTER 2
N/A
N/A
IGNITION 1
BLUE (+)
IGNITION SWITCH HARNESS
IGNITION 2
N/A
N/A
IGNITION 3
N/A
N/A
ACCESSORY/HEATER BLOWER 1
BLACK/WHITE (+)
IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2
BLACK/RED (+)
IGNITION SWITCH HARNESS
KEYSENSE
WHITE/BLUE (+)
IGNITION SWITCH HARNESS
PARKING LIGHTS ( - )
N/A
N/A
PARKING LIGHTS ( + )
LIGHT GREEN/RED (+)
LOW IN DRIVERS KICK PANEL
POWER LOCK
BLUE (-) SEE NOTE *
AT DOORLOCK CONTROL MODULE BEHIND RIGHT SIDE OF DASH
POWER UNLOCK
SAME AS LOCK WIRE
AT DOORLOCK MODULE BEHIND RIGHT SIDE OF DASH
DOOR TRIGGER
GREEN/ORANGE (-)
IN DRIVERS KICK PANEL
DOMELIGHT SUPERVISION
USE DOOR TRIGGER
TRUNK RELEASE
N/A
N/A
SLIDING POWER DOOR
N/A
N/A
HORN
VIOLET/WHITE (-)
STEERING COLUMN HARNESS
TACH
N/A
N/A
WAIT TO START LIGHT
N/A
N/A
BRAKE
GREEN/YELLOW (+)
AT SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM
WHITE/BLUE (+) (REQUIRES #R30-H RELAY)
IGNITION SWITCH HARNESS
ANTI-THEFT
TRANSPONDER ANTI-THEFT
TRANSPONDER @ IGNITION SWITCH TUMBLER
EXTRA INFORMATION
NOTE * THIS VEHICLE HAS A SINGLE WIRE DOORLOCKING SYSTEM THAT REQUIRES EXTRA PARTS. SEE DIAGRAM
