PART	COLOR	LOCATION
12 VOLT CONSTANT	Connect to Battery
STARTER	PINK/LIGHT BLUE (+) May not Have on some vehicles See NOTE *4	@ IGNITION HARNESS
STARTER 2	PURPLE/BROWN (-) See NOTE *1	@ IGNITION HARNESS, See DIAGRAM
IGNITION 1	PINK/WHITE (+)	@ IGNITION HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	Same wire as Starter #2 See NOTE *1	@ IGNITION HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	WHITE/PURPLE (+)	IN DRIVERS KICK PANEL, Harness to Rear of Vehicle.
POWER LOCK	LIGHT GREEN/DARK GREEN (1-Wire Door Lock System) See NOTE *2	IN DRIVERS KICK PANEL or CLUSTER, BROWN Plug, Pin 18, See DIAGRAM
POWER UNLOCK	Same wire See NOTE *2	See DIAGRAM
DOOR TRIGGER	See NOTE *3	IN EACH KICK PANEL or CLUSTER, BROWN Plug See DIAGRAM
DOMELIGHT SUPERVISION	YELLOW/WHITE (+), Requires #R30-H Relay	@ A Piller or CLUSTER, BROWN Plug, Pin 4
TRUNK RELEASE	N/A
SLIDING POWER DOOR	N/A
HORN	DARK GREEN/PURPLE (-)	@ HORN Switch in Column or CLUSTER, BLACK 20-Pin Plug, Pin 10
TACH	Any wire NOT BROWN/GRAY or BROWN/YELLOW	@ Any IGNITION COIL or FUEL INJECTOR
WAIT TO START LIGHT	N/A
BRAKE	DARK GREEN/GRAY (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS with FACTORY REMOTE ONLY!
ANTI-THEFT	CHRYSLERS SENTRY TRANSPONDER ANTI-THEFT SYSTEM	@ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 the STARTER #2 and the ACCESSORY #1 are the same wire, a (-)Negative thru a 180 Ohm Resistor is required to Start and a (-) Negative thru a 610 Ohm Resistor is Required to turn on the Accessories in the vehicle both will also require (2) R30-H Relays to connect See DIAGRAM. OR YOU CAN PURCHASE A PKUCH2GX, THATS A KEYLESS BYPASS AND ALSO DOES THE MUX IGNITION WITH THE NEED FOR RELAYS AND RESISTORS. NOTE *2 this vehicle uses a 1-Wire Door Locking System that will Require a (-)Negative thru a 1000 Ohm Resistor to LOCK and (-)Negative thru a 250 Ohm Resistor to UNLOCK on the same wire in the vehicle. Some units may also requires extra Relays (2) of Part #R30-H to connect See DIAGRAMS. NOTE *3 the DIRVERS DOOR is a PURPLE/BLACK (-) Pin 3, the PASSENGER DOOR is a PURPLE/WHITE (-) Pin 11, the DRIVERS REAR DOOR ia a PURPLE/GRAY (-) Pin 5 and the PASSENGER REAR DOOR is a PURPLE/YELLOW (-) Pin 6. when connecting to an ALAMR SYSTEM use all (4) wires and DIODE ISOLATE, See DIAGRAM NOTE *4 If you vehicle is not equipped with STARTER #1 in the Ignition Harness, the STARTER #2 DIAGRAM will make the vehicle Start and Run.