Vehicle
Wiring Details for your
2007 - Chevrolet Suburban Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2007 - Chevrolet Suburban . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED/BLACK (+) |
@ FUSEBOX, BLACK 40-Pin Plug, Pins F1 or E3 |
| STARTER |
WHITE (+) thru a 1300 Ohm Resistor, See NOTE *1 |
@ IGNITION SWITCH or BCM, LIGHT GREEN Plug, Pin 4, See NOTE *2 |
| STARTER
2 |
N/A |
|
| IGNITION
1 |
PINK (+) |
@ IGNITION SWITCH or BCM, LIGHT GREEN Plug, Pin 14, See NOTE *2 |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
BROWN (+) or YELLOW (+) |
@ IGNITION SWITCH or BCM, LIGHT GREEN Plug, Pin 21, See NOTE *2 |
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
LIGHT BLUE (-) |
|
| PARKING
LIGHTS ( + ) |
BROWN (+) Left and BROWN (+) Right, use both! See NOTE *3 |
@ Under Hood FUSEBOX, BLACK 30-Pin Plug, See DIAGRAM |
| POWER LOCK |
See NOTE *4 |
See DIAGRAM |
| POWER UNLOCK |
See NOTE *4 |
See DIAGRAM |
| DOOR TRIGGER |
See NOTE *5 |
See DIAGRAM |
| DOMELIGHT
SUPERVISION |
GRAY (+) |
@ BCM, NATURAL Plug, Pin 5, See NOTE *2 |
| TRUNK RELEASE |
PINK (-) Glass and GRAY (-) Gate, See NOTE *6 |
@ BCM, PINK Plug, Pins 24 and 13, See NOTE *2 |
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
TAN (-) |
@ HORN SWITCH or BCM, BROWN Plug, Pin 18, See NOTE *2 |
| TACH |
Any wire NOT: PINK, BROWN or BLACK |
@ IGNITION COIL |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
LIGHT BLUE/WHITE (+) |
@ SWITCH above BRAKE Pedal |
| FACTORY
ALARM DISARM |
LIGHT GREEN (-) |
@ DRIVER DOOR MODULE in DRIVERS DOOR, BROWN 16-Pin Plug, Pin 4 |
| ANTI-THEFT |
GM'S TRANSPONDER ANTI-THEFT SYSTEM |
@ IGNITION SWITCH TUMBLER |
| EXTRA
INFORMATION |
| NOTE *1 The STARTER/CRANK wire on this vehicle Requires a (+) Positive thru a 1300 Ohm to Start, See DIAGRAM
NOTE *2 The BCM is located to the LEFT of the STEERING COLUMN.
NOTE *3 The (+) Positive Parking Light Circuit on this vehicle to operate will require adding (2) 775 Relays, to Connect, See DIAGRAM
NOTE *4 This vehicle uses a Logic Controlled Door Locking System that requires adding extra Relay inside each door, to connect See DIAGRAM.
NOTE *5 The DRIVERS DOOR TRIGGER is a GRAY/BLACK (-) at the DRIVERS DOOR MODULE in the DRIVERS DOOR, BROWN 16-Pin Plug, Pin 13, the PASSENGER DOOR TRIGER is a BLACK/WHITE (-) or TAN/WHITE (-) at the PASSENGER DOOR MODULE in the PASSENGER DOOR, BROWN 16-Pin Plug, Pin 13. The DRIVERS REAR DOOR TRIGGER is a LIGHT BLUE/BLACK (-) PINK Plug, Pin 15 and the PASSENGER REAR DOOR TRIGGER is a LIGHT GREEN/BLACK (-) PINK Plug, Pin 14 both wires are located in the PINK Plug on the BCM, when connecting to an ALARM SYSTEM use all (4) FOUR wires and DIODE ISOLATE, See DIAGRAM.
NOTE *6 TEST these wires while opening the Lift Glass or Lift Gate from the Handle on the REAT HATCH.
|
| |