Vehicle
Wiring Details for your
2007 - Chevrolet Avalanche Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2007 - Chevrolet Avalanche . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED/BLACK (+) |
@ FUSEBOX, BLACK 40-Pin Plug, Pins F1 and E3 or connect to Battery |
| STARTER |
WHITE (+) See NOTE #1 |
@ IGNITION SWITCH HARNESS or BCM LIGHT GREEN Plug, Pin 4, See NOTE #2 |
| STARTER
2 |
N/A |
|
| IGNITION
1 |
PINK (+) |
@ IGNITION SWITCH HARNESS or BCM LIGHT GREEN Plug, Pin 14, See NOTE #2 |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
BROWN (+) |
@ IGNITION SWITCH HARNESS or BCM LIGHT GREEN Plug, Pin 21, See NOTE #2 |
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
LIGHT BLUE (-) |
@ HEADLIGHT Switch or BCM, TAN Plug, Oin 8, See NOTE #2 |
| PARKING
LIGHTS ( + ) |
BROWN (Left) and BROWN (Right) use both, Requires Extra Relay Part #R30-H See NOTE #3 |
@ Under Hood Fuse Box, 30-Pin BLACK Plug |
| POWER LOCK |
See NOTE #4 |
|
| POWER UNLOCK |
See NOTE #4 |
|
| DOOR TRIGGER |
See NOTE #5 |
|
| DOMELIGHT
SUPERVISION |
GRAY (+) |
@ BCM, TAN Plug, Pin 5, See NOTE #2 |
| TRUNK RELEASE |
N/A |
|
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
TAN (-) |
@ Horn Switch or @ BCM, BROWN Plug, Pin 18, See NOTE #2 |
| TACH |
Not PINK, BROWN or BLACK |
@ Any IGNITION COIL or FUEL-INJECTOR |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
LIGHT BLUE/WHITE (+) |
@ SWITCH above Brake Pedal or BCM, BROWN Plug, Pin 6 See NOTE #2 |
| FACTORY
ALARM DISARM |
LIGHT GREEN (-) |
in DRIVERS DOOR @ DOOR MODULE, BROWN 16-Pin Plug, Pin 4 |
| ANTI-THEFT |
GM's New PASS KEY 3 + Requires 791 Bypass Module |
@ IGNITION SWITCH TUMBLER |
| EXTRA
INFORMATION |
| NOTE #1 The STARTER #1 wire, WHITE (+) Requires a (+)Positive through a 1300 Ohm Resistor See DIAGRAM
NOTE #2 The BCM (Body Control Module) is located to the LEFT of the Steering Column.
NOTE #3 To connect up the (+) Positive Parking Lights will require an extra Relay Part #R30-H to connect See DIAGRAM
NOTE #4 This vehicle will Requires a Anti-Theft Bypass Module Part GMDL-BP to connect the Door Locks and Bypass the PASSLOCK 2 System. If not connecting up the Door locks use the 791 Bypass module.
NOTE #5 The Drivers Door is a GRAY/BLACK(-) at the Drivers Door Module, in the door, BROWN 16-Pin Plug, Pin 13. The Passenger Door is a BLACK/WHITE(-) at the Passenger Door Module in the door, BROWN 16-Pin Plug, Pin 13. The Drivers Rear Door is a LIGHT BLUE/BLACK(-) at the BCM, PINK Plug, Pin 15 and the Passenger Rear Door is a LIGHT GREEN/BLACK(-) at the BCM, PINK Plug, Pin 14. When connecting an Alarm use all 4 wires and DIODE ISOLATE, See DIAGRAM
|
|
|
|
|
|
