Vehicle
Wiring Details for your
2006-2010 Bmw 3 Series Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2006-2010 Bmw 3 Series . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED/GREEN(+) and RED/PURPLE(+) |
@ FRM, (51-PIN PLUG(X14260), PIN 2 and (51-PIN PLUG(X14261), PIN 34, NOTE #3 |
| STARTER |
BLACK (+) Low Current (NOT for REMOTE START) |
@ CAS, (41-PIN PLUG(X13376), PIN 22, NOTE #2 |
| STARTER
2 |
N/A |
|
| IGNITION
1 |
GREEN (+) Low Current (NOT for REMOTE START) |
@ CAS, (41-PIN PLUG(X13376), PIN 8, NOTE #2 |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
RED (+) Low Current (NOT for REMOTE START) |
@ CAS, (41-PIN PLUG(X13376), PIN 1, NOTE #2 |
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
N/A |
|
| PARKING
LIGHTS ( + ) |
BLACK/GREEN(+)(Left Front) and BLACK/BLUE(+)(Right Front), use both, NOTE #4 |
@ FRM, (51-PIN PLUG(X14261), PIN 50 and (51-PIN PLUG(X14260), PIN 8, NOTE #3 |
| POWER LOCK |
YELLOW/RED to YELLOW/BROWN (TYPE B) |
@CENTRAL LOCK Switch or CAS, (41-PIN PLUG(X13376), PIN 29, NOTE #2 |
| POWER UNLOCK |
Use LOCK wire |
|
| DOOR TRIGGER |
BROWN/WHITE to BROWN/GRAY/WHITE (-) |
in DRIVERS KICK PANEL or FRM, (51-PIN PLUG(X14261), PIN 50 and (51-PIN PLUG(X14261), PIN 24, NOTE #3 |
| DOMELIGHT
SUPERVISION |
RED/BLUE (-), NOTE #7 |
@ FRM, (51-PIN PLUG(X14261), PIN 50 and (51-PIN PLUG(X14260), PIN 35, NOTE #3 |
| TRUNK RELEASE |
GRAY/BROWN (-) |
@ TRUNK RELEASE Switch or CAS, (41-PIN PLUG(X13376), PIN 39, NOTE #2 |
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
PURPLE/BLUE (+) |
@ JUNCTION BOX, (PLUG(X11001), PIN 6 |
| TACH |
BLACK (AC) |
@ DATA LINK Connector, (PIN 9), Under Drivers Dash |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
BROWN/GRAY (+) |
@ BRAKE PEDAL Switch or CAS, (41-PIN PLUG(X13376), PIN 32, NOTE #2 |
| FACTORY
ALARM DISARM |
WHITE/BLACK (-), NOTE #6 |
in DRIVERS KICK PANEL or FRM, (51-PIN PLUG(X14261), PIN 50 and (51-PIN PLUG(X14261), PIN 46, NOTE #3 |
| ANTI-THEFT |
BMW'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 |
@ IGNITION SWITCH TUMBLER |
| EXTRA
INFORMATION |
| NOTE #1: BMW'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module,
Due to the SPECIAL IGNITION CIRCUIT you will need:
Part # CANMAX 400 Bypass Module to REMOTE START and DOOR LOCKS!
NOTE #2: the CAS, (Car Access System) is located Under the DRIVERS DASH.
NOTE #3: the FRM, (Footwell Module), is located in the DRIVERS KICK PANEL.
NOTE #4: the LEFT REAR Parking Light wire is a GRAY/PURPLE(+), at the FRM, (51-PIN PLUG
(X14260) PIN 14 and the RIGHT REAR Parking Light is a GRAY/YELLOW(+) at the
FRM, (51-PIN PLUG(X14260) PIN 41, use ALL wires and Relay Isolate.
NOTE #5: the JBE, (Junction Box Electronics), is located behind the GLOVE BOX, attached
to the BOTTOM of the JUNCTION BOX.
NOTE #6: TEST this wire while Turning the KEY in the DRIVERS DOOR.
NOTE #7: this wire is only available without ROOF FUNCTION CONTROL CENTER, on Vehicles
with ROOF FUNCTION CONTROL CENTER, this wire is CAN BUS Controled!
|
|
|
|
|
|
