Vehicle
Wiring Details for your
2006-2008 Hummer H3 Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2006-2008 Hummer H3 . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
ORANGE (+) |
BLACK PLUG , PIN A7 @ BCM, See NOTE #3 |
| STARTER |
See NOTE #1 |
|
| STARTER
2 |
N/A |
|
| IGNITION
1 |
WHITE/GREEN to DARK BLUE (+) |
@ IGNITION SWITCH HARNESS, or BCM, GRAY Plug, Pin B8, See NOTE #3 |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
WHITE/RED to BROWN (+) |
@ IGNITION SWITCH HARNESS, or BCM, GRAY Plug, Pin B7, See NOTE #3 |
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
BROWN/WHITE (-) |
@ HEADLIGHT Switch or BCM, GRAY Plug, Pin A7, See NOTE #3 |
| PARKING
LIGHTS ( + ) |
BROWN (+) |
in DRIVERS KICK PANEL or BCM, BLACK Plug, Pin A48, See NOTE #3 |
| POWER LOCK |
LIGHT BLUE (TYPE B) |
in EITHER KICK PANEL, @ DOOR HARNESS |
| POWER UNLOCK |
DARK BLUE (TYPE B) |
in EITHER KICK PANEL, @ DOOR HARNESS |
| DOOR TRIGGER |
See NOTE #4 |
@ BCM, BLACK Plug, See NOTE #3 |
| DOMELIGHT
SUPERVISION |
WHITE (-) |
@ BCM, BLACK Plug, Pin A46, See NOTE #3 |
| TRUNK RELEASE |
N/A |
|
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
GREEN to BLACK (-) |
@ HORN Switch or BCM, GRAY Plug, Pin A25, See NOTE #3 |
| TACH |
Any wire NOT: PINK or BLACK (AC) |
@ Any IGNITION COIL or FUEL-INJECTOR |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
LIGHT BLUE (+) |
@ SWITCH ABOVE BRAKE PEDAL |
| FACTORY
ALARM DISARM |
N/A |
|
| ANTI-THEFT |
GM'S MULTIPLEX IGNITION/ANTI-THEFT SYSTEM, See NOTE #1 |
|
| EXTRA
INFORMATION |
| NOTE #1: This vehicle is equipped with a Multiplex Ignition/Anti-theft system that requires a
Interface Bypass Module Part # XK09 to order go to the INTERFACE BYPASS
MODULE Page on this website.
NOTE #2: The PCM is located on the PASSENGER side of the Firewall, under the Hood of
the vehicle.
NOTE #3: The BCM is located in the PASSENGER KICK PANEL.
NOTE #4: the DRIVERS DOOR is a GRAY/BLACK (-) at Pin A32. The PASSENGER DOOR is a
LIGHT GREEN/BLACK (-) at Pin A38. The DRIVERS REAR DOOR is a BLACK/WHITE
(-) at Pin A39 and the PASSENGERS REAR DOOR is a LIGHT BLUE/BLACK (-) at Pin
A44, all wires are located at the BCM, BLACK plug. When connecting to an ALARM
SYSTEM use all 4 wires and DIODE ISOLATE, See DIAGRAM
|
|
|
|
|
|
