Vehicle
Wiring Details for your
2006-2008 Buick Lucerne Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2006-2008 Buick Lucerne . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED (+) |
@ BATTERY |
| STARTER |
See NOTE #5 |
|
| STARTER
2 |
N/A |
|
| IGNITION
1 |
PINK (+) |
@ IGNITION SWITCH HARNESS or BCM, GREEN Plug, Pin 14, See NOTE #1 |
| IGNITION
2 |
See NOTE #5 |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
BROWN (+) |
@ IGNITION SWITCH HARNESS or BCM, GREEN Plug, Pin 21, See NOTE #1 |
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
|
|
| PARKING
LIGHTS ( - ) |
LIGHT BLUE/TAN (-) |
@ HEADLIGHT SWITCH or BCM, WHITE Plug, Pin 8, See NOTE #1 |
| PARKING
LIGHTS ( + ) |
N/A |
|
| POWER LOCK |
See NOTE #5 |
|
| POWER UNLOCK |
See NOTE #5 |
|
| DOOR TRIGGER |
See NOTE #4 |
See DIAGRAM |
| DOMELIGHT
SUPERVISION |
GRAY/BLACK (+) |
in PASSENGER KICK PANEL or BCM, PINK Plug, Pin 1, See NOTE #1 |
| TRUNK RELEASE |
LIGHT BLUE (-) |
@ BCM, WHITE Plug, Pin 10, See NOTE #1 |
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
TAN (+) |
@ HORN Switch or BCM, BROWN Plug, Pin 18, See NOTE #1 |
| TACH |
ANY wire NOT PINK, PINK/GRAY or PINK/BLACK (AC) |
@ ANY FUEL-INJECTOR |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
LIGHT BLUE (+) |
in PASSENGER KICK PANEL or BCM, BROWN Plug, Pin 5, See NOTE #1 |
| FACTORY
ALARM DISARM |
LIGHT GREEN (-) |
@ DDM, BROWN Plug, Pin 4, See NOTE #2 |
| ANTI-THEFT |
GM'S MULTIPLEX IGNITION/TRANSPONDER SYSTEM, See NOTE #5 |
|
| EXTRA
INFORMATION |
| NOTE #1: The BCM (Body Control Module) is located ABOVE the PASSENGER KICK PANEL.
NOTE #2; The DDM is the DRIVERS DOOR MODULE located in the DRIVERS DOOR.
NOTE #3; The DRIVERS DOOR TRIGGER is a GRAY/BLACK (-) at the DRIVERS DOOR MODULE in the DRIVERS DOOR, BROWN Plug, Pin 13, the PASSENGER DOOR TRIGER is a TAN/WHITE (-) at the PASSENGER DOOR MODULE in the PASSENGER DOOR, BROWN Plug, Pin 13. The DRIVERS REAR DOOR TRIGGER is a LIGHT BLUE/BLACK (-) PINK Plug, Pin 15 and the PASSENGER REAR DOOR TRIGGER is a LIGHT GREEN/BLACK (-) PINK Plug, Pin 14 both wires are located in the PINK Plug on the BCM, when connecting to an ALARM SYSTEM use all (4) FOUR wires and DIODE ISOLATE, See DIAGRAM.
NOTE #4: TEST this wire while turning the KEY in the DRIVERS DOOR KEY CYLINDER.
NOTE #5: THIS VEHICLE REQUIRES A INTERFACE BYPASS MODULE PART # XK09 AND PART
#RFLCHGM TO REMOTE START AND OPERATE DOOR LOCKS,
TO ORDER GO TO THE INTERFACE BYPASS MODULE PAGE ON THIS WEBSITE.
|
|
|
|
|
|
