Vehicle
Wiring Details for your
2006-2008 Audi A4 Wiring Diagram |
Printer Friendly Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2006-2008 Audi A4 . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
PART |
COLOR |
LOCATION |
12 VOLT
CONSTANT |
RED (+) |
@ IGNITION SWITCH, (8-PIN PLUG), PIN 3 |
STARTER |
RED/BLACK (+) |
@ IGNITION SWITCH, (8-PIN PLUG), PIN 5 |
STARTER
2 |
BLUE (+) |
@ IGNITION SWITCH, (8-PIN PLUG), PIN 1 |
IGNITION
1 |
BLACK (+) |
@ IGNITION SWITCH, (8-PIN PLUG), PIN 6 |
IGNITION
2 |
N/A |
|
IGNITION
3 |
N/A |
|
ACCESSORY/HEATER
BLOWER 1 |
YELLOW/BLACK (+) |
@ IGNITION SWITCH, (8-PIN PLUG), PIN 2 |
ACCESSORY/HEATER
BLOWER 2 |
GRAY/YELLOW (+) |
@ IGNITION SWITCH, (8-PIN PLUG), PIN 4 |
KEYSENSE |
N/A |
|
PARKING
LIGHTS ( - ) |
N/A |
|
PARKING
LIGHTS ( + ) |
GRAY (+), NOTE #3 |
@ HEADLIGHT Switch or VESCM, (32-PIN PLUG), PIN 25, NOTE #2 |
POWER LOCK |
PURPLE/BLUE (TYPE B) |
@ DRIVERS DOOR CONTROL MODULE, (32-PIN PLUG), PIN 10 |
POWER UNLOCK |
PURPLE/RED (TYPE B) |
@ DRIVERS DOOR CONTROL MODULE, (32-PIN PLUG), PIN 27 |
DOOR TRIGGER |
GRAY/PURPLE (-) |
@ DRIVERS DOOR CONTROL MODULE, (12-PIN PLUG), PIN 3 |
DOMELIGHT
SUPERVISION |
BROWN/WHITE (-) |
@ CSCM, (12-PIN PLUG), PIN 2, NOTE #4 |
TRUNK RELEASE |
RED (-) |
@ DRIVERS DOOR CONTROL MODULE, (32-PIN PLUG), PIN 9 |
SLIDING
POWER DOOR |
N/A |
|
HORN |
GREEN/YELLOW (-) |
@ VESCM, (32-PIN PLUG), PIN 1, NOTE #2 |
TACH |
See NOTE #5 |
@ Any FUEL -INJECTOR |
WAIT TO
START LIGHT |
N/A |
|
BRAKE |
RED/BLACK (+) |
@ BRAKE PEDAL Switch or VESCM, (32-PIN PLUG), PIN 15, NOTE #2 |
FACTORY
ALARM DISARM |
PURPLE/GREEN (-),(Requires Double Pulse), See NOTE #6 |
@ DRIVERS DOOR CONTROL MODULE, (12-PIN PLUG), PIN 7 |
ANTI-THEFT |
AUDI'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 |
@ IGNITION SWITCH TUMBLER |
EXTRA
INFORMATION |
NOTE #1: AUDI'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module,
Part # 791 Bypass for REMOTE STARTING ONLY, requires extra ignition key for
Operation.
to order go to the SECURITY BYPASS MODULE Page on this website
NOTE #2: the VESCM, (Vehicle Electronic System Control Module) is located,
UNDER the DRIVERS DASH.
NOTE #3: the HEADLIGHT SWITCH OFF wire will need to be INTERRUPTED with a RELAY at the
HEADLIGHT SWITCH, the wire is a PURPLE @ the VESCM, (32-PIN
PLUG), PIN 32.
NOTE #4: the CSCM, (Comfort System Control Module) is located in FRONT of the DRIVERS SEAT
under the CARPET, in a Protective Box.
NOTE #5: Any wire NOT RED STRIPED(2.0T) and any wire NOT GREEN STRIPED(3.2) all TEST (AC)
NOTE #6: TEST this wire while Turning the KEY in the DRIVERS DOOR, this wire also UNLOCKS the doors.
|
|
|
|
|