| NOTE *1 The PCM (Powertrain Control Module) is located BEHIND the DRIVERS SIDE HEADLIGHT in the AIR CLEANER Assembly.
NOTE *2 There is a WHITE wire and a WHITE/BLACK wire located in the IGNITION SWITCH HARNESS, or at the BCM, in the GREEN Plug, Pins 2 and 4, these wires perform the Starter , Ignition #2 and Key Sense functions. These wires in most cases will not be needed!! No more information at this time.
NOTE *3 The BCM (Body Control Module) is located ABOVE the PASSENGER KICK PANEL.
NOTE *4 The DDM is the DRIVERS DOOR MODULE located in the DRIVERS DOOR.
NOTE *5 The DRIVERS DOOR TRIGGER is a GRAY/BLACK (-) at the DRIVERS DOOR MODULE in the DRIVERS DOOR, BROWN Plug, Pin 13, the PASSENGER DOOR TRIGER is a TAN/WHITE (-) at the PASSENGER DOOR MODULE in the PASSENGER DOOR, BROWN Plug, Pin 13. The DRIVERS REAR DOOR TRIGGER is a LIGHT BLUE/BLACK (-) PINK Plug, Pin 15 and the PASSENGER REAR DOOR TRIGGER is a LIGHT GREEN/BLACK (-) PINK Plug, Pin 14 both wires are located in the PINK Plug on the BCM, when connecting to an ALARM SYSTEM use all (4) FOUR wires and DIODE ISOLATE, See DIAGRAM.
NOTE *6 TEST this wire while turning the KEY in the DRIVERS DOOR KEY CYLINDER.
NOTE *7 An Extra Relay Part # R30-H is Required to Delay the Ignition Timing for Remote Starting, See DIAGRAM. or bypass module PKUGM2X would eliminate the need for the relays for ignition timing and accessory drop out. The PKUGM2X is also a keyless bypass that would eliminate the need for the #791.
NOTE *8 An Extra Relay Part # R30-H is Required to Delay to Drop Out the Accessory Circuit before Remote Starting of this Vehicle, See DIAGRAM
NOTE *9 This vehicles doorlocks require a bypass GMDL6X with 4.00 fireware for keyless entry.
|