| NOTE #1: This vehicle MAY BE equipped with a Special Anti-theft key, to remote start you will
need a Bypass module 791,(use this module IF you have a extra ignition key to
place inside the 791 to remote start, if you do not have an extra key to use or wish
not to have a key placed inside this bypass module, we OFFER a KEYLESS INTERFACE
BYPASS MODULE that does not require a key to be placed inside the bypass module,
this is Part # PKALL or PKFM, either one will work, to order, go to the INTERFACE
BYPASS MODULE PAGE on this website.
NOTE #2: The VSM (Vehicle Security Module) is located to the RIGHT of the GAS Pedal, just
above the Transmission hump and below the Radio. the VSM is NOT Accessible
from the Radio opening.
NOTE #3: Vehicles WITHOUT a FACTORY KEYLESS Entry Remote Control are a TYPE "C" Door
Locking System. Vehicles WITH a FACTORY KEYLESS Entry Remote Control are a
TYPE "B" Door Locking System and the LOCK wire is a WHITE/RED (TYPE B) and the
UNLOCK is a BLACK/WHITE TYPE B), BOTH are located in the Drivers Kick Panel, at the
Door Harness.
NOTE #4: On GAS Engines the TACH wire is any wire that is NOT: RED/LIGHT GREEN or
RED/YELLOW (AC) at any IGNITION COIL or FUEL-INJECTOR. On DIESEL Engines
the TACH wire is a LIGHT GREEN/WHITE (AC) wire in a 5-Pin Harness held up with
WHITE tape located behind the Parking Brake Release.
NOTE #5: On this vehicle you can not use the WAIT TO START wire, you must use the WAIT TO
START TIMER Programming in your Installation manual.
|
