Note #1: CHRYSLER'S MUX/TRANSPONDER IGNITION , Requires a INTERFACE BYPASS MODULE for
REMOTE STARTING and KEYLESS ENTRY, Part # DB-ALL or XK09 either Module will work,
to order go to the INTERFACE BYPASS MODULE Page on this website.
NOTE #3: this vehicle uses a 1-Wire Door Locking System, LOCK requires a (-)Negative thru a
330 Ohm Resistor and UNLOCK requires a (-)Negative thru a 100 Ohm Resistor,
some units will also require 2 extra relays, to connect, See DIAGRAM
NOTE #4: the DRIVERS DOOR is a PURPLE (-) wire in the WHITE plug Pin 3, the PASSENGER
DOOR is a PURPLE/WHITE (-) in the WHITE plug Pin 3. the DRIVERS REAR DOOR is a
PURPLE/GRAY (-) in the GRAY 26 Pin plug, Pin 10 and the PASSENGER REAR DOOR is
a PURPLE/YELLOW (-) in the GRAY 26 Pin plug, Pin 9. When connecting to an ALARM
SYSTEM, use all 4 DOOR TRIGGER wires and DIODE ISOLATE, to connect,
See DIAGRAM
NOTE #5: the REAR HATCH RELEASE will require a (-)Negative thru a 4700 Ohm Resistor and a
extra Relay Part #775, to connect, See DIAGRAM
NOTE #6: to turn on the parking Lights on this vehicle will require a (-) Negative thru a 2700
Ohm and may also require a #775 Relay, to connect See DIAGRAM
|