PART	COLOR	LOCATION
12 VOLT CONSTANT	BLUE (+)	@ IGNITION HARNESS
STARTER	YELLOW (+)	@ IGNITION HARNESS
STARTER 2	WHITE (+)	@ IGNITION HARNESS
IGNITION 1	WHITE (+)	@ IGNITION HARNESS
IGNITION 2	PINK (+)	@ IGNITION HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	RED (+)	@ IGNITION HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	BLUE (-) See NOTE *1	@ IGNITION HARNESS
PARKING LIGHTS ( - )	WHITE (-)	@ HEADLIGHT SWITCH or BECU, 26-Pin Plug, Pin 21, See NOTE *2
PARKING LIGHTS ( + )	GREEN (+)	@ FUSE BOX, TOP Left, 30-Pin Plug, Pin 10
POWER LOCK	BLUE to LIGHT BLUE (Negative (-)) See NOTE *3	IN DRIVERS KICK PANEL, 12-Pin Plug, Pin 4
POWER UNLOCK	PINK to LIGHT GREEN (Negative (-)) Requires Double Pulse	IN DRIVERS KICK PANEL, 12-Pin Plug, Pin 9
DOOR TRIGGER	NOTE *4	See DIAGRAM
DOMELIGHT SUPERVISION	WHITE (-), Requires Part #R30-H Relay	@ LEFT SIDE of FUSE BOX, 6-Pin Plug, pin 2
TRUNK RELEASE	N/A
SLIDING POWER DOOR	N/A
HORN	LIGHT GREEN (-)	@ HORN SWITCH or FUSE BOX, TOP 36-Pin Plug, Pin 28
TACH	GRAY	@ DATA LINK Connector under Dash, Pin 9
WAIT TO START LIGHT	N/A
BRAKE	BLUE (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS with UNLOCK
ANTI-THEFT	TOYOTA'S TRANSPONDER ANTI-THEFT SYSTEM	@ IGNITION TUMBLER

EXTRA INFORMATION

NOTE *1 The KEYSENCE BLUE (-) wire can be used as a DISARM wire for the Factory Security, a constant (-) Negative to this wire will DISARM. NOTE *2 The BECU (Body Electronic Control Unit) is attached to the BACK of the FUSE BOX. NOTE *3 TEST the LOCK and UNLOCK wires while turning the Key in the DRIVERS DOOR KEY CYLINDER. NOTE *4 The DRIVERS DOOR is a WHITE (-) at the FUXE BOX, in the TOP LEFT 30-Pin Plug, Pin 21. The PASSENGER DOOR is a BROWN (-) at the FUXE BOX, in the TOP RIGHT 16-Pin Plug, Pin 14. The DRIVERS REAR DOOR is a LIGHT BLUE (-) in the DRIVERS KICK PANEL, in a 20-Pin Plug, Pin 13. And the PASSENGER REAR DOOR is a LIGHT GREEN (-) at the FUXE BOX, in the TOP LEFT 14-Pin Plug, Pin 7. When connecting to an ALARM SYSTEM use all 4 wires and DIODE ISOLATE, See DIAGRAM.