Vehicle
Wiring Details for your
2006 -2007 Pontiac Solstice Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2006 -2007 Pontiac Solstice . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED/BLACK (+) (10 Gauge) |
@ BCM, C3, Pin D1, See NOTE *1 |
| STARTER |
YELLOW (Not for Remote Starting) |
@ ECM, BLUE Plug, Pin 56, See NOTE *2 and NOTE *3 |
| STARTER
2 |
N/A |
|
| IGNITION
1 |
YELLOW (+) (20 Gauge) |
@ IGNITION HARNESS or BCM, C4, Pin D3, See NOTE *1 |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
BROWN (+) (12 Gauge) |
@ BCM, C4, C8, See NOTE *1 |
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
BROWN/WHITE (-) |
@ HEADLIGHT SWITCH or BCM, Connector C2, Pin 5, See NOTE *1 |
| PARKING
LIGHTS ( + ) |
BROWN (+) |
IN DRIVERS KICK PANEL or BCM, C3, Pin A7 See NOTE *1 |
| POWER LOCK |
Use Motor Wires, GRAY (5 Wire Reverse Polarity) |
IN DRIVERS KICK PANEL or BMC, C3, Pin A4, See NOTE *1 |
| POWER UNLOCK |
Use Motor Wires, TAN (5 Wire Reverse Polarity) |
IN DRIVER KICK PANEL or BCM, C3, Pin B1, See NOTE *1 |
| DOOR TRIGGER |
GRAY/BLACK (-) Drivers Door and TAN/WHITE (-) Passenger Door, use both See NOTE *4 |
IN EACH KICK PANEL or BCM, C1, Pins 22 and 19, See NOTE *1 |
| DOMELIGHT
SUPERVISION |
GRAY (-) |
@ BCM, C3, Pin A10, See NOTE *1 |
| TRUNK RELEASE |
TAN (-) |
@ RELEASE SWITCH or BCM C2 PIN 10, GRAY Plug, See NOTE *1 |
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
TAN (-) |
@ HORN SWITCH or BCM, C2, Pin 14, See NOTE *1 |
| TACH |
NOT PINK/BLACK |
@ Any FUEL-INJECTOR |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
LIGHT BLUE (+) |
IN PASSENGER KICK PANEL or BCM, C1, Pin 53, See NOTE *1 |
| FACTORY
ALARM DISARM |
DISARMS with FACTORY REMOTE ONLY!!! |
|
| ANTI-THEFT |
GM's PASSKEY 3 (PK3 on Steel Shaft of Ignition Key) TRANSPONDER SYSTEM |
@ IGNITION SWITCH TUMBLER |
| EXTRA
INFORMATION |
| NOTE *1 the BCM (Body Control Module) is part of the FUSE/RELAY BOX below the GLOVE BOX, the BCM will have these connectors: C1 a 72-Pin GRAY Plug, C2 a 72-Pin GRAY Plug, C3 a 41-Pin RED Plug, and C4 a 68-Pin LIGHT GRAY Plug located on the BACK of the BCM.
NOTE *2 the ECM (Engine Control Module) is in the DRIVERS side REAR Corner of the Engine Compartment.
NOTE *3 There is a WHITE wire and a WHITE/BLACK wire in the IGNITION HARNESS or the BCM, C2, Pins 56 and 62 that work as the Starter, and Second Ignition, at this time there is no information on if these wires will need to be wired in to Remote Start See DIAGRAM
NOTE *4 When connecting to an Alarm System, use both wires and DIODE ISOLATE, See DIAGRAM
|
|
|
|
|
|
