PART	COLOR	LOCATION
12 VOLT CONSTANT	LIGHT BLUE/RED (+)	@ IGNITION HARNESS
STARTER	PINK/ORANGE (+)	@ IGNITION HARNESS
STARTER 2	PURPLE/BROWN (-) See NOTE *1	@ IGNITION HARNESS, See DIAGRAM
IGNITION 1	PINK/LIGHT GREEN (+)	@ IGNITION HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	See NOTE *1	@ IGNITION HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	N/A
POWER LOCK	PURPLE/DARK GREEN (1-Wire Door Locking System) See NOTE *2	@ DRIVERS DOOR MODULE in DRIVERS DOOR
POWER UNLOCK	Same Wire	See DIAGRAMS
DOOR TRIGGER	See NOTE *3	IN EACH KICK PANEL or CLUSTER Connector 3
DOMELIGHT SUPERVISION	YELLOW/ORANGE (-), Requires Part #R30-H Relay	@ UNDER DASH LIGHT or CLUSTER Connector 2, Pin 12
TRUNK RELEASE	ORANGE/PURPLE (-) See NOTE *4, Requires Part #R30-H Relay	IN DRIVERS KICK PANEL or CLUSTER, Connector 3, Pin 8
SLIDING POWER DOOR	N/A
HORN	DARK GREEN/ORANGE (+)	@ HORN or IMP, Connector 2, Pin 35, See NOTE *5
TACH	ANY wire NOT RED/TAN or DARK GREEN/LIGHT GREEN	@ ANY IGNITION COIL or FUEL-INJECTOR
WAIT TO START LIGHT	N/A
BRAKE	WHITE/TAN (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS with FACTORY REMOTE ONLY!!
ANTI-THEFT	CHRYSLERS SENTRY TRANSPONDER ANTI-THEFT SYSTEM	@ IGNITION TUMBLER

EXTRA INFORMATION

NOTE *1 THE STARTER #2 AND ACCESSORY WIRE are the same, The STARTER #2 wire requires a (-) Negative thru a 180 Ohm resistor, and an extra Relay part #R30-H, the ACCESSORY wire requires a (-) Negative thru a 560 Ohm resistor and an extra relay part #R30-H to connect See DIAGRAM NOTE *2 This vehicle uses a 1-Wire Door Locking System, the LOCK requires a (-) Negative thru a 330 Ohm resistor the UNLOCK requires a (-) Negative thru a 100 Ohm resistor. Some units will also require extra relays Part 778 to connect See DIAGRAMS. NOTE *3 The DRIVERS DOOR is a PURPLE (-) at Pin 6, the PASSENGER DOOR is a PURPLE/WHITE (-) Pin 7, the DRIVERS REAR DOOR is a PURPLE/GRAY (-) Pin 4 and the PASSENGER REAR DOOR is a PURPLE/YELLOW Pin 5 when connecting to an ALARM SYSTEM use all 4 wires ans DIODE ISOLATE See DIAGRAM NOTE *4 TEST this wire while opening the REAR GLASS from the SWITCH on the REAR HATCH NOTE *5 The IPM (Integrated Power Module) is located on the DRIVERS FENDER, behind the BATTERY