PART	COLOR	LOCATION
12 VOLT CONSTANT	YELLOW (+) and LIGHT GREEN/PURPLE (+)	@ IGNITION SWITCH HARNESS
STARTER	DARK GREEN (+)	@ IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	RED/LIGHT GREEN (+)	@ IGNITION SWITCH HARNESS
IGNITION 2	RED/BLACK (+)	@ IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	GRAY/YELLOW (+)	@ IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	DARK/BLUE/LIGHT GREEN (+)	@ IGNITION SWITCH HARNESS
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	BROWN (+)	@ HEADLIGHT Switch or VSM, GREEN Plug, Pin 2, See NOTE *1
POWER LOCK	PINK/YELLOW (5 Wire Reverse Polarity) See NOTE *2	in DRIVERS KICK PANEL, @ DOOR HARNESS
POWER UNLOCK	PINK/LIGHT GREEN (5 Wire Reverse Polarity) See NOTE *2	in DRIVERS KICK PANEL, @ DOOR HARNESS
DOOR TRIGGER	Use DOMELIGHT Supervison wire
DOMELIGHT SUPERVISION	BLACK/LIGHT BLUE (+)	@ PASSENGER KICK PANEL or Cluster Blue Plug, Pin 26
TRUNK RELEASE	N/A
SLIDING POWER DOOR	N/A
HORN	DARK BLUE (-)	@ HORN SWITCH or VSM, GREEN Plug, Pin 6, See NOTE *1
TACH	See NOTE *3
WAIT TO START LIGHT	See NOTE *4
BRAKE	LIGHT GREEN (+)	@ SWITCH above BRAKE PEDAL
FACTORY ALARM DISARM	N/A
ANTI-THEFT	N/A

EXTRA INFORMATION

NOTE *1 The VSM (Vehicle Security Module) is located to the RIGHT of the GAS Pedal, just above the Transmission hump and below the Radio. the VSM is NOT Accessible from the Radio opening. NOTE *2 Vehicles WITHOUT a FACTORY KEYLESS Entry Remote Control are a TYPE "C" Door Locking System. Vehicles WITH a FACTORY KEYLESS Entry Remote Control are a TYPE "B" Door Locking System and the LOCK wire is a WHITE/RED (Negative (-)) and the UNLOCK is a BLACK/WHITE Negative (-)), BOTH are located in the Drivers Kick Panel, at the Door Harness. NOTE *3 On GAS Engines the TACH wire is any wire that is NOT: RED/LIGHT GREEN or RED/YELLOW at any IGNITION COIL or FUEL-INJECTOR. On DIESEL Engines the TACH wire is a LIGHT GREEN/WHITE wire in a 5-Pin Harness held up with WHITE tape located behind the Parking Brake Release. NOTE *4 On this vehicle you can not use the WAIT TO START wire, you must use the WAIT TO START TIMER Programming in your Installation manual.