PART	COLOR	LOCATION
12 VOLT CONSTANT	RED (x2) and RED/LIGHT BLUE (+)	@ IGNITION HARNESS
STARTER	PINK/LIGHT BLUE (+)	@ IGNITION HARNESS
STARTER 2	N/A
IGNITION 1	PINK/LIGHT GREEN	@ IGNITION HARNESS
IGNITION 2	PINK (+)
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	PURPLE (-) and PINK/WHITE (+) See NOTE *1	@ IGNITION HARNESS, See DIAGRAM
ACCESSORY/HEATER BLOWER 2	PINK/YELLOW (+) (X2)	@ IGNITION HARNESS
KEYSENSE	N/A
PARKING LIGHTS ( - )	PINK/RED (-)	@ HEADLIGHT Switch or cluster, GRAY 16-Pin Plug, Pin 5
PARKING LIGHTS ( + )	PINK/RED (+) and WHITE/ORANGE (+) USE BOTH! See DIAGRAM	@ IMP, 20-Pin Plug, Pins 15 and 17 See NOTE *2
POWER LOCK	PURPLE/DARK GREEN 1-Wire System, See NOTE *3	in DRIVERS KICK PANEL or Cluster GRAY 16-Pin Plug, Pin 3
POWER UNLOCK	Same wire See NOTE *3	Same wire
DOOR TRIGGER	See NOTE *4	in Each Kick Panel See Diagram
DOMELIGHT SUPERVISION	YELLOW/ORANGE (+)	@ Cluster, WHITE Plug, Pin 11
TRUNK RELEASE	N/A
SLIDING POWER DOOR	N/A
HORN	DARK GREEN/PURPLE (-)	@ HORN Switch
TACH	Any wire not RED	@ Any Ignition Coil or Fuel-Injector
WAIT TO START LIGHT	N/A
BRAKE	WHITE/LIGHT BLUE (+)	@ Switch Above Brake Pedal
FACTORY ALARM DISARM	Disarms with Factory Remote Only
ANTI-THEFT	CHRYSLERS SENTRY TRANSPONDER, See NOTE *5	@ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 the PURPLE (-) Accessory wire must be powered up using an extra Relay Part R30-H, See DIAGRAM NOTE *2 the IMP (Interrated Power Module) is located at the FUSE/RELAY Box on the Drivers Side Fender. NOTE *3 the 1 Wire door locks on this vehicle will require a 330 Ohm Resistor to LOCK and a 100 Ohm Resistor to UNLOCK See DIAGRAM NOTE *4 DRIVERS Front door is a PURPLE (-) in the GRAY 26-Pin Plug Pin 6. The PASSANGER Front Door is a PURPLE/WHITE (-) in a WHITE plugPin 23. The DRIVERS REAR Door is a PURPLE/GRAY (-) in a GRAY 26-Pin Plug, Pin 8 and the PASSANGER REAR Door is a PERPLE/YELLOW (-) in a WHITE Plug, Pin 22. When connecting to an Alarm system use all 4 wires and DIODE ISOLATE, See DIAGRAM NOTE *5 The CHEYSLER'S SENTRY TRANSPONDER ANTI-THEFT System is STANDARD on the SLT Package and LARAMIE Models.