PART	COLOR	LOCATION
12 VOLT CONSTANT	LIGHT BLUE/RED (+)	@ IGNITION SWITCH HARNESS
STARTER	PINK/DARK GREEN (+)	@ IGNITION SWITCH HARNESS
STARTER 2	PURPLE/BROWN (-) See NOTE *1 and *2	@ IGNITION SWITCH HARNESS, See DIAGRAM
IGNITION 1	PINK/WHITE (+)	@ IGNITION SWITCH HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	PURPLE/BROWN (-) See NOTE *1 and *2	@ IGNITION SWITCH HARNESS, See DIAGRAM
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	WHITE/BROWN (-) See NOTE *6	@ HEADLIGHT SWITCH, See DIAGRAM
PARKING LIGHTS ( + )	WHITE/PURPLE (+)	In PASSENGER KICK PANEL, BROWN 26-Pin Plug, Pin 26
POWER LOCK	PURPLE/DARK GREEN (1-Wire Door Locking System) See NOTE *3	In DRIVERS KICK PANEL, See DIAGRAM
POWER UNLOCK	Same wire, See DIAGRAM	See DIAGRAMS
DOOR TRIGGER	See NOTE *4	IN EACH KICK PANEL
DOMELIGHT SUPERVISION	YELLOW/WHITE (-), Requires #R30-H Relay	IN PASSENGER A PILLAR
TRUNK RELEASE	PRUPLE/TAN (-) See NOTE *5, Requires #R30-H Relay	IN PASSENGER KICK PANEL, See DIAGRAM
SLIDING POWER DOOR	N/A
HORN	DARK GREEN/ORANGE (+)	@ HORN under HOOD
TACH	ANY wire NOT BROWN/YELLOW	@ ANY COIL or FUEL-INJECTOR
WAIT TO START LIGHT	N/A
BRAKE	DARK GREEN /WHITE (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS with IGNITION and TRANSPONDER KEY
ANTI-THEFT	CHRYSLER'S SENTRY KEY, a TRANSPONDER SYSTEM	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 and *2 this vehicle requires a Special Circuit that requires (2) Relays and (2) Resistors, Starter #2 requires a (-)Negative thru a 180 Ohm Resistor and Accessory requires a (-)Negative thru a 610 Ohm Resistor, these circuits must be used for the vehicle to Remote Start, to connect, See DIAGRAM NOTE *3 this vehicle uses a 1-Wire Door Locking System, LOCK requires a (-)Negative thru a 330 Ohm Resistor and UNLOCK requires a (-)Negative thru a 100 Ohm Resistor, some units will also require 2 extra relays, to connect, See DIAGRAM NOTE *4 the DRIVERS DOOR is a PURPLE (-) wire in the WHITE plug Pin 3, the PASSENGER DOOE is a PURPLE/WHITE (-) in the WHITE plug Pin 3. the DRIVERS REAR DOOR is a PURPLE/GRAY (-) in the GRAY 26 Pin plug, Pin 10 and the PASSENGER REAR DOOR is a PURPLE/YELLOW (-) in the GRAY 26 Pin plug, Pin 9. When connecting to an ALARM SYSTME, use all 4 DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM NOTE *5 the REAR HATCH RELEASE will require a (-)Negative thru a 4700 Ohm Resistor and a extra Relay Part #R30-H, to connect, See DIAGRAM NOTE *6 to turn on the parking Lights on this vehicle will require a (-) Negative thru a 2700 Ohm and may also require a #R30-H Relay, to connect See DIAGRAM