Vehicle
Wiring Details for your
2006 -2007 Chevrolet Impala Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2006 -2007 Chevrolet Impala . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED/WHITE (+) |
@ IGNITION HARNESS or BCM, BLUE Plug, Pin 3, See NOTE *1 |
| STARTER |
YELLOW (Not for Remote Starting) |
@ ECM, See NOTE *2 |
| STARTER
2 |
N/A |
|
| IGNITION
1 |
PINK (+) |
@ IGNITION HARNESS or BCM, GREEN Plug, Pin 14, See NOTE *1 |
| IGNITION
2 |
See NOTE *3 |
See DIAGRAM |
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
BROWN (+) |
@ IGNITION HARNESS or BCM, GREEN Plug, Pin 21, See NOTE *1 |
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
BROWN/WHITE (-) |
@ HEADLIGHT SWITCH or BCM, WHITE Plug, Pin 8, See NOTE *1 |
| PARKING
LIGHTS ( + ) |
PURPLE (+) LEFT and BROWN/WHITE (+) RIGHT, USE BOTH wires, will require (2) extra Relays, See DIAGRAM |
in PASSENGER KICK Panel, Harness to Rear of Vehicle. |
| POWER LOCK |
ORANGE/BLACK (Negative (-)) |
IN DRIVER KICK PANEL or BCM, GRAY Plug, Pin 12, See NOTE *1 |
| POWER UNLOCK |
ORANGE/BLACK (Negative (-)) |
IN DRIVERS KICK PANEL or BCM, GRAY Plug, Pin 11, See NOTE *1 |
| DOOR TRIGGER |
See NOTE *4 |
IN EACH KICK PANEL or BCM, PINK Plug, See NOTE *1 |
| DOMELIGHT
SUPERVISION |
GRAY/BLACK (+) |
IN DRIVERS KICK PANEL or BCM, PINK Plug, pin 1, See NOTE *1 |
| TRUNK RELEASE |
LIGHT BLUE (-) |
@ TRUNK RELEASE SWITCH or BCM, WHITE Plug, Pin 10, See NOTE *1 |
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
TAN (-) |
@ HORN SWITCH or BCM, BROWN Plug, Pin 18, See NOTE *1 |
| TACH |
NOT PINK/BLACK |
@ Any FUEL-INJECTOR |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
LIGHT BLUE (+) |
IN DRIVERS KICK PANEL or BCM, PINK Plug, Pin 22, See NOTE *1 |
| FACTORY
ALARM DISARM |
FACTORY REMOTE ONLY |
|
| ANTI-THEFT |
PASSKEY 3 (PK3) TRANSPONDER |
@ IGNITION SWITCH TUMBLER |
| EXTRA
INFORMATION |
| NOTE *1 The BCM (Body Control Module) is located to the LEFT of the Steering Column.
NOTE *2 The ECM (Engine Control Module) is located behind the Drivers Side Headlight, in the Air Cleaner Assembly.
NOTE *3 There is a WHITE wire and a WHITE/BLACK wire in the IGNITION HARNESS or the BCM, GREEN Plug, Pins 2 and 4 that work as the Starter, and Second Ignition, See DIAGRAM
NOTE *4 The DRIVERS DOOR is a GRAY/BLACK (-) Pin 10, the PASSENGER DOOR is a TAN/WHITE (-) Pin 8, the DRIVERS REAR DOOR is a BLUE/BLACK (-) Pin 15 and the PASSENGER REAR DOOR is a LIGHT GREEN/BLACK (-) Pin 14, when connecting to an Alarm System, use all (4) wires and Diode Isolate.
|
|
|
|
|
|
