Vehicle
Wiring Details for your
2006 -2007 Chevrolet Hhr Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2006 -2007 Chevrolet Hhr . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED/BLACK (+) (10 Gauge) |
@ BCM, C3, Pin D1, RED Plug, See NOTE *1 |
| STARTER |
YELLOW (Not for Remote Starting) See DIAGRAM |
@ ECM, BLUE Plug, Pin 56 or 46, See NOTE *2 |
| STARTER
2 |
N/A |
|
| IGNITION
1 |
YELLOW (+) (20 Gauge) |
@ IGNITION SWITCH HARNESS or BCM, C4, Pin D3, GRAY Plug, See NOTE *1 |
| IGNITION
2 |
|
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
BROWN (+) (12 Gauge) |
@ IGNITION SWITCH HARNESS or BCM, C4, Pin C8, LIGHT GRAY Plug, See NOTE *1 |
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
See NOTE *3 |
|
| PARKING
LIGHTS ( - ) |
BROWN/WHITE (-) |
@ HEADLIGHT SWITCH or BCM, C2, Pin 5, GRAY Plug, See NOTE *1 |
| PARKING
LIGHTS ( + ) |
BROWN (+) |
IN DRIVERS KICK PANEL or BCM, C3, Pin A7, GRAY Plug, See NOTE *1 |
| POWER LOCK |
WHITE (1-Wire Door Lock System) See NOTE *4 |
IN DRIVERS KICK PANEL or BCM, C1, Pin 7, GRAY Plug, See NOTE *1 |
| POWER UNLOCK |
Same wire, See DIAGRAM |
See DIAGRAMS |
| DOOR TRIGGER |
GRAY/BLACK (-) Drivers side, TAN/WHITE (-) Passengers side, use both and Diode Isolate |
IN EACH KICK PANEL or BCM, C1, Pins 22 and 19, GRAY Plug, See NOTE *1 |
| DOMELIGHT
SUPERVISION |
GRAY (-) |
@ BCM, C3, Pin A10, RED Plug, See NOTE *1 |
| TRUNK RELEASE |
WHITE/BLACK (-) |
@ BCM, C1, Pin 69, GRAY Plug, See NOTE *1 |
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
TAN (-) |
@ BCM, C2, Pin 14, GRAY Plug, See NOTE *1 |
| TACH |
NOT PINK or PINK/BLACK |
@ Any FUEL-INJECTOR |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
LIGHT BLUE (+) |
@ SWITCH above BRAKE PEDAL or BCM, C2, Pin 54, GRAY Plug, See NOTE *1 |
| FACTORY
ALARM DISARM |
FACTORY REMOTE ONLY |
|
| ANTI-THEFT |
GM's NEW PASSLOCK 2 See NOTE *3 |
NEW PASSLOCK 2 Requires Part XK06 Bypass |
| EXTRA
INFORMATION |
| NOTE *1 The BCM (Body Control Module) is part of the FUSE/RELAY BOX on the FRONT PASSENGER side of the CENTER CONSOLE. The BCM will have these connectors: C1 is a 72-Pin GRAY Plug, C2 is a 72-Pin GRAY Plug, C3 is a 41-Pin RED Plug and C4 is a 68-Pin LIGHT GRAY Plug, the C4 LIGHT GRAY Plug, is located on the BACK of the BCM and can be reached by removing the plastic panel from the Center Console on the DRIVERS SIDE .
NOTE *2 The ECM (Engine Control Module) is located on the DRIVERS SIDE FENDER, in front of the Underhood Fuse Box.
Note *3 this vehicle reqires a Anti-Theft Bypass Module XK06 OR PKUGM2X to order contact DIRECT WHOLESALE at 1-800-659-0764
|
|
|
|
|
|
