PART	COLOR	LOCATION
12 VOLT CONSTANT	Connect to BATTERY ONLY
STARTER	DARK GREEN/YELLOW (+)	@ IGNITION HARNESS or Starter Button (SRT-10)
STARTER 2	PURPLE/BROWN (-) Requires a 180 Ohm Resistor and Relay, See NOTE *1	@ IGNITION HARNESS, See DIAGRAM
IGNITION 1	PINK/WHITE (+)	@ IGNITION HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	Same as Second Starter wire, uses 610 Ohm Resistor and Relay, See NOTE *1	@ IGNITION HARNESS, See DIAGRAM
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	WHITE/LIGHT GREEN (-) Requires a 1130 Ohm Resistor and Relay, See NOTE *2	@ HEADLIGHT SWITCH or INSTRUMENT CLUSTER, Small GRAY Plug, Pin 5
PARKING LIGHTS ( + )	WHITE/YELLOW (+) LEFT Side and WHITE/GRAY (+) RIGHT Side, use both, requires (2) extra Relays, See DIAGRAM	@ HARNESS, TOP of DRIVERS FENDER
POWER LOCK	PURPLE/DARK GREEN, 1-Wire System, Requires Extra Resistors, See NOTE *3	IN DRIVERS KICK PANEL or INSTRUMENT CLUSTER, Small GRAY Plug, Pin 3
POWER UNLOCK	Same wire, See DIAGRAM	See DIAGRAMS
DOOR TRIGGER	See NOTE *4	IN EACH KICK PANEL or INSTRUMENT CLUSTER, LARGE GRAY Plug
DOMELIGHT SUPERVISION	YELLOW/LIGHT BLUE (+), Requires #R30-H Relay	@ A Pillar or INSTRUMENT CLUSTER, WHITE Plug, Pin 21
TRUNK RELEASE	N/A
SLIDING POWER DOOR	N/A
HORN	DARK GREEN/PURPLE (-)	@ HORN SWITCH or INSTRUMENT CLUSTER, LARGE GRAY Plug, Pin 14
TACH	DARK BLUE/GRAY See NOTE *5	@ PCM, BLACK/ORANGE Plug, Pin 34
WAIT TO START LIGHT	N/A
BRAKE	WHITE/TAN (+)	@ SWITCH above BRAKE PEDAL
FACTORY ALARM DISARM	FACTORY REMOTE ONLY
ANTI-THEFT	CHRYSLER'S SENTRY KEY, A TRANSPONDER SYSTEM	@ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 the STARTER #2 wire and ACCESSORY wire are combined into 1-Wire System, the Starter #2 will require a (-)Negative thru a 180 Ohm Resistor and an Extra Relay Part #R30-H the Accessory will require (-)Negative thru a 610 Ohm Resistor and an extra Relay Part #R30-H, to connect See DIAGRAM. NOTE *2 the Negative Parking Lights require a (-)Negative thru a 1130 Ohm Resistor or a 2200 Ohm Resistor and an Extra Relay Part #R30-H, to connect See DIAGRAM NOTE *3 this vehicle uses a 1-Wire Door Locking System that requires a (-) Negative thru 820 Ohm Resistor to Lock and requires (-) Negative thru a 330 Ohm Resistor to Unlock, to connect, See DIAGRAM NOTE *4 the DRIVERS DOOR is a PURPLE (-) at Pin 1, the PASSENGER DOOR is a PURPLE/WHITE (-) at Pin 4, the DRIVERS REAR DOOR is a PURPLE/ORANGE (-) or PURPLE/GRAY (-) at Pin 2, the PASSENGER REAR DOOR is a PURPLE/YELLOW (-) or TAN/YELLOW (-) at Pin 3. when connecting to an Alarm System use all 4 wires and Diode Isolate, to connect, See DIAGRAM NOTE *5 the PCM (Powertrain Control Module) is on the PASSENGER SIDE FIREWALL. The BLACK/ORANGE Plug is the SECOND plug down from the TOP. On the SRT-10 the TACH is in the BLACK Plug, Pin 18. On DIESEL'S the Tach wire is at the ECM, on the lower drivers side of the engine, FRONT 60-Pin plug, Pin 24 or at the Camshaft Position Sensor just LEFT of the ECM in a 3-Pin plug.