| NOTE *1 the PURPLE (-) Accessory wire must be powered up using an extra Relay Part R30-H, See DIAGRAM
NOTE *2 the (-) Negative Parking Lights on this Vehicle require a (-) Negative or Ground thru a 1100 Ohm Resistor a Relay Part #R30-H must be used, to Connect See DIAGRAM.
NOTE *3 the (+) Positive Parking Lights on this vehicle require adding (2) Extra Relays Part #R30-H to turn ON both the Left and the Right Parking Light circuits in this vehicle, See DIAGRAM
NOTE *4 this vehicle uses a 1-Wire Door Locking System, a (-) Negative thru a 330 Ohm Resistor will LOCK and (-) Negative thru a 100 Ohm Resistor will UNLOCK, if your unit DOES NOT have On-Board Door Lock Relays, (2) Extra Relays Part #R30-H will be required, See DIAGRAM.
On vehicles without memory Seats, the Lock/Unlock wire can be found in the Drivers Kick Panel at the Door Harness. With Memory Seats, this wire is located in the Drivers Door at the Drivers Door Memory Mirror Module.
NOTE *5 DRIVERS Front door is a PURPLE (-). The PASSANGER Front Door is a PURPLE/WHITE (-). The DRIVERS REAR Door is a PURPLE/GRAY (-) and the PASSANGER REAR Door is a PERPLE/YELLOW (-). Tje REAR DOOR Trigger wires are located in a LARGE 74-Pin Plug near the FUSEBOX. For the FRONT DOOR Trigger wires: On vehicles without memory Seats, the FRONT DOOR Trigger wires are located in the same 74-pin plug as the REAR DOOR Triggers. With Memory Seats, the DRIVERS DOOR Trigger wire is located in the Drivers Door at the Drivers Door Memory Mirror Module. the PASSENGER DOOR Trigger wire is located in the PASSANGER DOOR at the PASSENGER MEMORY MIRROR MODULE. When connecting to an Alarm system use all 4 wires and DIODE ISOLATE, See DIAGRAM
NOTE *6 CHRYSLER'S SENTRY KEY, TRANSPONDER SYSTEM is Standard on the LIMITED and SLT V8 Models and Optional on the Adventurer and on the SLT V6 Models.
|
