PART	COLOR	LOCATION
12 VOLT CONSTANT	(2) RED (+) 12 VOLTS CONSTANT	@ IGNITION SWITCH HARNESS
STARTER	YELLOW (+)	@ IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	PINK (+)	@ IGNITION SWITCH HARNESS
IGNITION 2	WHITE (+) See NOTE *1	@ IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	ORANGE (+)	@ IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	GRAY/BLACK (-)	@ HEAD LIGHT Switch or BCM, BROWN Plug, Pin B2 See NOTE *2
PARKING LIGHTS ( + )	BROWN (+)	in DRIVER KICK PANEL
POWER LOCK	See NOTE *3
POWER UNLOCK	See NOTE *3
DOOR TRIGGER	See NOTE *4	See DIAGRAM
DOMELIGHT SUPERVISION	GRAY/BLACK (+)	@ BCM, BLACK Plug, Pin F See NOTE *2
TRUNK RELEASE	N/A
SLIDING POWER DOOR	N/A
HORN	BLACK/YELLOW to BLACK (-)	@ HORN Switch or BCM, GRAY Plug, Pin B9 See NOTE *2
TACH	WHITE	@ INSTRUMENT CLUSTER, pIN a5 or PCM, See NOTE *5
WAIT TO START LIGHT	N/A
BRAKE	WHITE (+)	@ SWITCH above BRAKE PEDAL
FACTORY ALARM DISARM	LIGHT GREEN (-)	@ DRIVERS DOOR MODULE in DRIVERS DOOR
ANTI-THEFT	YELLOW (1-6 Volts DC) BLACK (-) and RED/WHITE (NOT USED) GM's PASSLOCK 2	@ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 This IGNITION #2 WIRE MUST BE connected to IGNITION #2 on the REMOTE START to prevent a CHECK ENGINE LIGHT from turning on and to PREVENT TRANSMISSION DAMAGE. NOTE *2 The BCM (Body Control Module) is located under the DRIVERS SIDE of the DASH, the BCM will have 6 Plug with the PURPLE Plug on the back of the module. NOTE *3 This vehicle will Requires a Anti-Theft Bypass Module Part GMDL-BP to connect the Door Locks and Bypass the PASSLOCK 2 System. If not connecting up the Door locks use the 791 Bypass module. NOTE *4 The DRIVERS DOOR TRIGGER is a GRAY/BLACK (-) at the DRIVERS DOOR MODULE in the DRIVERS DOOR, the PASSENGER DOOR TRIGER is a BLACK/WHITE (-) at the PASSENGER DOOR MODULE in the PASSENGER DOOR. The DRIVERS REAR DOOR TRIGGER is a LIGHT BLUE/BLACK (-) Pin A3 and the PASSENGER REAR DOOR TRIGGER is a LIGHT GREEN/BLACK (-) Pin A2 both wires are located in the PURPLE Plug on the back of the BCM, when connecting to an ALARM SYSTEM use all (4) FOUR wires and DIODE ISOLATE, See DIAGRAM. NOTE *5 The PCM (Powertrain Control Module) is located in the ENGINE COMPARTMENT to the LEFT of the FAN SHROUD. The TACH wire is in the GREEN Plug, Pin 10.