Vehicle
Wiring Details for your
2005-2008 Chevrolet Uplander Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2005-2008 Chevrolet Uplander . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED or RED/BLACK (+) |
@ BATTERY or FUSEBOX |
| STARTER |
YELLOW (+) |
@ IGNITION SWITCH HARNESS or BCM, C1 CONNECTOR, PIN 21, SEE NOTE #2 |
| STARTER
2 |
N/A |
|
| IGNITION
1 |
PINK (+) |
@ IGNITION SWITCH HARNESS or BCM, C1 CONNECTOR, PIN 22, SEE NOTE #2 |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
BROWN (+) |
@ IGNITION SWITCH HARNESS or BCM, C1 CONNECTOR, PIN 23, SEE NOTE #2 |
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
BROWN/WHITE (-) |
@ BCM, C3 CONNECTOR, PIN 8, SEE NOTE #2 |
| PARKING
LIGHTS ( + ) |
BROWN (+) |
@ FUSEBOX or IN PASSENGER KICK PANEL, HARNESS to REAR of Vehicle |
| POWER LOCK |
ORANGE/BLACK or PINK/BLACK (TYPE B) |
@ BCM, C2 CONNECTOR, PIN 2, SEE NOTE #2 |
| POWER UNLOCK |
ORANGE/BLACK (TYPE B) |
@ BCM, C2 CONNECTOR, PIN 11, SEE NOTE #2 |
| DOOR TRIGGER |
SEE NOTE #3 |
@ BCM, C2, SEE NOTE #2 |
| DOMELIGHT
SUPERVISION |
GRAY/BLACK (+) |
@ BCM, C1, PIN 43, SEE NOTE #2 |
| TRUNK RELEASE |
N/A |
|
| SLIDING
POWER DOOR |
LT. BLUE/BLACK (-)(LEFT) and LT. BLUE(-)(RIGHT) |
@ PASSENGER SIDE, B-PILLAR, BLACK 23-PIN PLUG |
| HORN |
TAN (-) |
@ HORN SWITCH or BCM, C1, PIN 4, SEE NOTE #2 |
| TACH |
Any wire NOT PINK (AC) |
@ ANY FUEL-INJECTOR |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
WHITE (+) |
@ BCM, C2, PIN 30, SEE NOTE #2 |
| FACTORY
ALARM DISARM |
PURPLE (-) |
@ BCM, C2, PIN 24, SEE NOTE #2 |
| ANTI-THEFT |
GM'S TRANSPONDER ANTI-THEFT SYSTEM, SEE NOTE #1 |
|
| EXTRA
INFORMATION |
| NOTE #1: This vehicle Requires a 791 BYPASS MODULE and an Extra Programmed Ignition key
to Interface with the Factory Anti-theft system, to order the 791 Bypass Module,
go to the SECURITY BYPASS MODULE Page on this website.
NOTE #2: The BCM is located to the LEFT of the Steering Column, C1 is a BLACK, 52-PIN
CONNECTOR, C2, is a BLACK, 52-PIN CONNECTOR and C3, is a BLACK, 18-PIN
CONNECTOR.
NOTE #3: The Door Trigger for the Drivers door is a GRAY/BLACK (-) PIN 26, the Passenger
Front door trigger is a TAN/WHITE (-) PIN 17. The Drivers Rear door trigger is a LT.
BLUE/BLACK (-) PIN 7 and the Passenger Rear door trigger is a LT. GREEN/BLACK
(-), PIN 5. When connecting to an alarm system use all 4 wires and diode isolate.
|
|
|
|
|
|
