Vehicle
Wiring Details for your
2005-2007 Pontiac G6 Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2005-2007 Pontiac G6 . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
Connect to BATTERY ONLY |
|
| STARTER |
See NOTE #1 |
|
| STARTER
2 |
N/A |
|
| IGNITION
1 |
PINK (+) |
|
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
BROWN (+) |
@ BACK of IGNITION SWITCH |
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
BROWN/WHITE (-) |
@ HEADLIGHT SWITCH or BCM C2, PIN 5, See NOTE #2 |
| PARKING
LIGHTS ( + ) |
BROWN (+) |
@ HEADLIGHT SWITCH or BCM, C3, PIN A7, See NOTE #2 |
| POWER LOCK |
WHITE (1-Wire System) See NOTE #5 |
@ BCM, C1, Pin 66, See NOTE #2 |
| POWER UNLOCK |
Same wire, See DIAGRAM |
See DIAGRAMS |
| DOOR TRIGGER |
See NOTE #3 |
@ BCM, C1, See NOTE #2 |
| DOMELIGHT
SUPERVISION |
GRAY (-) |
@ BCM, C3, Pin A10, See NOTE #2 |
| TRUNK RELEASE |
BROWN/WHITE (-) |
@ BCM, C1, PIN 71, See NOTE #2 |
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
TAN (-) |
@ BCM, C2, PIN 14, See NOTE #2 |
| TACH |
See NOTE #4 |
@ IGNITION CONTROL MODULE |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
WHITE (+) |
@ BCM, C1, PIN 24, See NOTE #2 |
| FACTORY
ALARM DISARM |
LT.GREEN ( - ) NEG . THRU 500OHMS (use a 470 + 33 ohm 1/2watt connected end to end) |
DOOR HARNESS IN DRIVERS KICK OR @ BCM,C1, PIN 35, See NOTE #2 |
| ANTI-THEFT |
PONTIAC'S MULTIPLEX IGNITION/TRANSPONDER, See NOTE #1 |
|
| EXTRA
INFORMATION |
| NOTE #1: THIS VEHICLE REQUIRES A SPECIAL INTERFACE BYPASS MODULE TO REMOTE START, PART # DB-ALL FOR THE 2005-2006 AND PART # DB-ALL or XK09 FOR THE 2007, THESE INTERFACES WILL ALSO DO THE KEYLESS ENTRY WITH NO EXTRA PARTS NEEDED, TO ORDER PLEASE GO TO THE INTERFACE BYPASS MODULE PAGE ON THIS WEBSITE.
NOTE #2: the BCM (Body Control Module) is part of the FUSE/RELAY BOX, on the FRONT PASSENGER SIDE of the CENTER CONSOLE, the connectors are: C1-72pin GRAY Plug, C2-72pin GRAY Plug, C3-41pin RED Plug, and C4-68pin LIGHT GRAY Plug.
NOTE #3: the DRIVERS DOOR is a GRAY/BLACK (-) PIN 51, the PASSENGER DOOR is a TAN/WHITE (-) PIN 72, the DRIVERS REAR DOOR is a LIGHT BLUE/BLACK (-) PIN 54 and the PASSENGER REAR DOOR is a LIGHT GREEN/BLACK (-) PIN 53. When connecting to an ALARM SYSTEM, use all (4) DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM
NOTE #4: on the 2.2L engine, use the WHITE or ORANGE wire, on the 3.5L 6-Cylinder engine, use the PURPLE, ORANGE/WHITE or LIGHT BLUE.
NOTE #5: this vehicle uses a 1-Wire DOOR LOCKING SYSTEM that requires a (-)Negative thru a 1500 Ohm Resistor to UNLOCK and a straight (-)Negative to LOCK, some units will also require (2) extra relays Part #775, to connect, See DIAGRAM
|
|
|
|
|
|
