Vehicle
Wiring Details for your
2005-2007 Land Rover Range Rover Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2005-2007 Land Rover Range Rover . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED (+), 30 AMP |
@ IGNITION SWITCH HARNESS |
| STARTER |
BLACK/YELLOW (+) |
@ IGNITION SWITCH HARNESS |
| STARTER
2 |
N/A |
|
| IGNITION
1 |
GREEN (+) (Thick wire) |
@ IGNITION SWITCH HARNESS |
| IGNITION
2 |
GREEN (+) (Thin wire) |
@ IGNITION SWITCH HARNESS |
| IGNITION
3 |
PURPLE/BLACK (+) |
@ IGNITION SWITCH HARNESS |
| ACCESSORY/HEATER
BLOWER 1 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
N/A |
|
| PARKING
LIGHTS ( + ) |
Each Controlled Separately! |
|
| POWER LOCK |
YELLOW/RED (-), NOTE #2 |
@ LOCK SWITCH or BCU, (WHITE, 26-PIN PLUG), PIN 24, NOTE #1 |
| POWER UNLOCK |
Same as LOCK wire, NOTE #2 |
|
| DOOR TRIGGER |
See NOTE #3 |
@ BCU, NOTE #1 |
| DOMELIGHT
SUPERVISION |
RED/BLUE (+) |
@ BCU, (BLACK, 20-PIN PLUG), PIN 20, NOTE #1 |
| TRUNK RELEASE |
GRAY/BROWN (-) |
@ RELAEASE SWITCH or BCU, (BLACK, 26-PIN PLUG), PIN 11, NOTE #1 |
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
PURPLE/GRAY (+) |
@ FUSE BOX, (BLACK, 10-PIN PLUG), PIN 3 |
| TACH |
Any wire NOT RED/WHITE, (AC) |
@ Any FUEL-INJECTOR |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
BLACK/BLUE (+) |
@ LIGHTING SWITCH MODULE |
| FACTORY
ALARM DISARM |
WHITE/BLACK (-), NOTE #4, Double Pulse will UNLOCK Doors |
@ DRIVERS DOOR MODULE, in DRIVERS DOOR |
| ANTI-THEFT |
LAND ROVER'S TRANSPONDER ANTI-THEFT SYSTEM, Requires 791 Bypass Module |
@ IGNITION SWITCH TUMBLER |
| EXTRA
INFORMATION |
| NOTE #1: the BCU (Body Control Unit) is located under the PASSENGER SEAT.
NOTE #2: a (-)Negative or TYPE B pluse on this wire will alternate between LOCK and UNLOCK, See DIAGRAM
NOTE #3: the DRIVERS DOOR is a BROWN/WHITE (-) at the Drivers Door Module in the Drivers door, the PASSENGER DOOR is a BROWN/WHITE (-) at the Passenger Door Module in the Passenger Door, the DRIVERS REAR DOOR is a BROWN/GRAY (-) at the BCU (See NOTE #1), WHITE 26-Pin plug, Pin 7 and the PASSENGER REAR DOOR is a BROWN/GRAY to BROWN/WHITE (-) at the BCU, 26-PIN Plug, Pin 6. When connecting to an ALARM SYSTEM, use all 4 DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM
NOTE #4: TEST this wire while turning the Key in the Drivers Door.
|
|
|
|
|
|
