PART	COLOR	LOCATION
12 VOLT CONSTANT	WHITE/BLUE (+) and WHITE/RED (+)	IGNITION SWITCH HARNESS
STARTER	GREEN/BLACK (+) See NOTE *1	IGNITION SWITCH HARNESS
STARTER 2	BLACK/WHITE (+) See NOTE *1	IGNITION SWITCH HARNESS
IGNITION 1	BLACK/RED (+)	IGNITION SWITCH HARNESS
IGNITION 2	BLUE/YELLOW (+)	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	WHITE/GREEN (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	GREEN/BLACK (-)	IGNITION SWITCH HARNESS
PARKING LIGHTS ( - )	GREEN (-)	@ HEADLIGHT SWITCH or BCEU, PIN 13, See NOTE *2
PARKING LIGHTS ( + )	GREEN (+)	@ FUSE BOX 13-Pin plug, Pin 10
POWER LOCK	PURPLE (Negative (-)) See NOTE *3	IN DRIVERS KICK PANEL, 10-Pin plug, Pin 4
POWER UNLOCK	GREEN/BLACK (Negative (-)) (Requires Double Pulse)	IN DRIVERS KICK PANEL, 10-Pin plug, Pin 8
DOOR TRIGGER	See NOTE *4	@ FUSE BOX
DOMELIGHT SUPERVISION	BLUE (-), Requires Part #R30-H Relay	@ FUSE BOX, BLACK 13-Pin plug, pin 9
TRUNK RELEASE	N/A
SLIDING POWER DOOR	N/A
HORN	GREEN/RED (-)	@ FUSE BOX, 18-PIN Plug, Pin 10
TACH	BLACK/WHITE	@ DATA LINK CONNECTOR,pin 9, See NOTE *5
WAIT TO START LIGHT	N/A
BRAKE	BLUE (+)	@ FUSE BOX, 11-PIN Plug, Pin 2
FACTORY ALARM DISARM	DISARMS with KEYSENSE wire, See NOTE *6	@ IGNITION SWITCH HARNESS
ANTI-THEFT	TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES 791 BYPASS MODULE AND EXTRA IGNITION KEY See NOTE *7	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 this vehicle uses (2) STARTER/CRANK wires, when connecting to a Remote Starter you must connect BOTH STARTER/CRANK wires to the STARTER/CRANK wire from the Remote Starter. NOTE *2 the BECU (Body Electronic Control Unit) is attached to the back of the FUSE BOX, with a single 26-Pin Plug. NOTE *3 when testing the DOOR LOCK and UNLOCK wires, you must TEST these wires when turning the kEY in the DRIVERS DOOR KEY CYLINDER ONLY. NOTE *4 the DRIVERS DOOR is a GREEN/YELLOW (-) in the 18-pin plug, pin 7, the PASSENGER DOOR is a RED/BLACK (-) in a 22-pin plug, pin 8, the REAR DOORS are a PINK/BLACK (-) in an 18-pin plug pin 6, when connecting to an ALARM SYSTEM, use all (3) DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM NOTE *5 the DATA LINK CONNECTOR is located under the DRIVERS SIDE of the DASH. NOTE *6 THE KEYSENSE WIRE WILL DISARM THE VEHICLE WITHOUT UNLOCKING THE DOORS BY APPLYING A (-)NEGATIVE TO THIS WIRE DURING REMOTE STARTING. NOTE *7 the TRANSPONDER ANTI-THEFT System is standard on all V-6 models.