PART	COLOR	LOCATION
12 VOLT CONSTANT	WHITE/BLUE (+)	IGNITION SWITCH HARNESS
STARTER	BLACK/WHITE (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	BLACK/RED (+)	IGNITION SWITCH HARNESS
IGNITION 2	BLACK/YELLOW (+)	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	PINK (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	YELLOW/GREEN (-)	@ BECU, WHITE Plug, Pin 13, See NOTE *2
PARKING LIGHTS ( - )	GREEN (-)	@ BECU, GRAY Plug, Pin 7, See NOTE *2
PARKING LIGHTS ( + )	GREEN (+)	IN DRIVERS KICK PANEL, HARNESS to REAR of VEHICLE
POWER LOCK	See NOTE *1	See DIAGRAM
POWER UNLOCK	See NOTE *1	See DIAGRAM
DOOR TRIGGER	See NOTE *3	@ BECU, See NOTE *2
DOMELIGHT SUPERVISION	WHITE (-)	@ BECU, BLACK Plug, Pin 3, See NOTE *2
TRUNK RELEASE	N/A
SLIDING POWER DOOR	N/A
HORN	BROWN/YELLOW (-)	@ BECU, WHITE PLUG, Pin 26, See NOTE *2
TACH	YELLOW/GREEN	@ ECM, 2ND PLUG FROM RIGHT, Pin 1, See NOTE *4
WAIT TO START LIGHT	N/A
BRAKE	GREEN/YELLOW (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS with KEYSENSE wire, See NOTE *5	@ IGNITION SWITCH HARNESS
ANTI-THEFT	TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES 791 BYPASS MODULE AND EXTRA IGNITION KEY	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 THIS VEHICLE WILL REQUIRE AN EXTRA RELAY, PART #R30-H AND DIODES TO DO THE KEYLESS ENTRY FUNCTION, to connect, See DIAGRAM NOTE *2 THE BECU (Body Electronic Control Unit) IS LOCATED ABOVE THE DRIVERS KICK PANEL NOTE *3 THE DRIVERS DOOR IS A GRAY/RED(-) IN THE BLACK PLIG, PIN 12. THE PASSENGER DOOR IS A LIGHT GREEN/BLACK(-) IN THE WHITE PLUG, PIN 22. THE DRIVERS REAR DOOR IS A RED/WHITE(-) IN THE BLACK PLUG, PIN 7. THE PASSENGER REAR DOOR IS A RED/WHITE(-) IN THE WHITE PLUG, PIN 8. WHEN CONNECTING TO AN ALARM SYSTEM, USE ALL (4) DOOR TRIGGER WIRES AND DIODE ISOLATE, TO CONNECT, See DIAGRAM NOTE *4 THE ECM (Engine Control Module) IS LOCATED BEHIND THE GLOVE BOX NOTE *5 THE KEYSENSE WIRE WILL DISARM THE VEHICLE WITHOUT UNLOCKING THE DOORS BY APPLYING A (-)NEGATIVE TO THIS WIRE DURING REMOTE STARTING.