PART	COLOR	LOCATION
12 VOLT CONSTANT	BLACK (+)	IGNITION SWITCH HARNESS
STARTER	BLUE (+) See NOTE *4	IGNITION SWITCH HARNESS
STARTER 2	RED (+) See NOTE *4	IGNITION SWITCH HARNESS
IGNITION 1	YELLOW (+)	IGNITION SWITCH HARNESS
IGNITION 2	GREEN (+)	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	GRAY (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	BLACK (-)	IGNITION SWITCH HARNESS
PARKING LIGHTS ( - )	DO NOT USE!!!
PARKING LIGHTS ( + )	DO NOT USE!!!
POWER LOCK	BLACK to BROWN (Negative (-)) See NOTE *1	IN DRIVERS KICK PANEL, 20-Pin plug, Pin 9
POWER UNLOCK	GRAY to PURPLE (Negative (-)) (Requires Double Pulse)	IN DRIVERS KICK PANEL, 20-Pin plug, Pin 19
DOOR TRIGGER	See NOTE *2	IN EACH KICK PANEL, HARNESS TO REAR OF VEHICLE
DOMELIGHT SUPERVISION	BROWN (-), Requires Part #R30-H Relay	RIGHT side of FUSE BOX, 12-Pin plug, Pin 5
TRUNK RELEASE	BLUE (-), Requires Part #R30-H Relay	@ TRUNK RELEASE SWITCH
SLIDING POWER DOOR	N/A
HORN	GRAY (-)	@ HORN SWITCH in STEERING COLUMN COVER
TACH	WHITE	@ ECM, Second plug from top, Pin 1, See NOTE *3
WAIT TO START LIGHT	N/A
BRAKE	WHITE (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS with KEYSENSE wire	@ IGNITION SWITCH HARNESS
ANTI-THEFT	TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES 791 BYPASS MODULE AND EXTRA IGNITION KEY	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 the DOOR LOCK/UNLOCK wires will only TEST when turning the key in the DRIVERS DOOR KEY CYLINDER. NOTE *2 the DRIVERS DOOR is a PINK to BLUE (-), the PASSENGER DOOR is a PURPLE to BLUE (-), the DRIVERS REAR DOOR is a BLACK (-) and the PASSENGER REAR DOOR is a GRAY (-) When connecting to an ALARM SYSTEM, use all 4 DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM NOTE *3 the ECM (Engine Control Module) is located BEHIND the GLOVE BOX. NOTE *4 this vehicle uses 2 STARTER/CRANK wires at the IGNITION SWITCH HARNESS, when connecting to a Remote Starter, you must connect BOTH STARTER/CRANK wires to the STARTER/CRANK wire from the Remote Starter.