PART	COLOR	LOCATION
12 VOLT CONSTANT	RED (+) (X2)	IGNITION SWITCH HARNESS
STARTER	LIGHT BLUE/RED (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	PINK/LIGHT GREEN (+)	IGNITION SWITCH HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	PINK/YELLOW (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	PINK/YELLOW (+)	IGNITION SWITCH HARNESS
KEYSENSE	N/A
PARKING LIGHTS ( - )	PINK/RED (-) See NOTE *1	@ HEADLIGHT Switch or BCM, 22-PIN Plug Pin 5, See NOTE *4
PARKING LIGHTS ( + )	DO NOT USE!!!
POWER LOCK	TAN/DARK BLUE (1-Wire Door Lock System) See NOTE *2	@ BACK of FUSEBOX, TOP LEFT Plug, Pin 14
POWER UNLOCK	Same wire, See DIAGRAM	See DIAGRAMS
DOOR TRIGGER	See NOTE *3	@ BCM, See NOTE *4
DOMELIGHT SUPERVISION	BLACK/WHITE (-) or YELLOW/LIGHT BLUE (-) Requires Part #R30-H Relay	@ BACK of FUSEBOX, TOP LEFT Plug, Pin 30
TRUNK RELEASE	LIGHT GREEN/WHITE (-)	@ BCM, 26-PIN PLUG, PIN 17, See NOTE *4
SLIDING POWER DOOR	N/A
HORN	DARK GREEN/PURPLE (-)	@ HORN SWITCH
TACH	Any wire NOT RED/ORANGE or PINK/GRAY	@ ANY FUEL-INJECTOR or IGNITION COIL
WAIT TO START LIGHT	N/A
BRAKE	WHITE/TAN (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS with FACTORY REMOTE ONLY!!!
ANTI-THEFT	TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES 791 BYPASS MODULE AND EXTRA IGNITION KEY	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 the PARKING LIGHTS require a (-)Negative thru a 910 Ohm Resistor and an extra Relay part #R30-H, to connect, See DIAGRAM NOTE *2 to LOCK requires a (-)Negative thru a 1400 Ohm Resistor and UNLOCK requires a (-)Negative thru a 426 Ohm Resistor, some units will also require 2 extra relays part #R30-H, to connect, See DIAGRAM NOTE *3 the DRIVERS DOOR is a TAN (-) in the GRAY 26-PIN plug, pin 4, the PASSENGER DOOR is a TAN/RED (-) in the GRAY 26-PIN plug, pin 5, the DRIVERS REAR DOOR is a TAN/ORANGE (-) in the GRAY 22-PIN plug, pin 3, the PASSENGER REAR DOOR (-) is a TAN/YELLOW (-) is a TAN/YELLOW (-) in the GRAY 26-PIN plug, pin 22. When connecting to an ALARM SYSTEM, use all 4 DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM NOTE *4 THE BCM (Body Control Module) IS ATTACHED TO THE LEFT OF THE FUSE BOX.