PART	COLOR	LOCATION
12 VOLT CONSTANT	Connect to BATTERY ONLY
STARTER	PINK/ORANGE (+)	IGNITION SWITCH HARNESS
STARTER 2	PURPLE/BROWN (-) See NOTE *1	IGNITION SWITCH HARNESS, See DIAGRAM
IGNITION 1	PINK/LIGHT GREEN (+)	IGNITION SWITCH HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	PURPLE/BROWN (-) Same wire as STARTER #2, See NOTE *2	IGNITION SWITCH HARNESS, See STARTER #2 DIAGRAM
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	DO NOT USE!
POWER LOCK	PURPLE/DARK GREEN (1-Wire System) See NOTE *3	IN DRIVERS KICK PANEL or Cluster Connector 3, pin 17 See DIAGRAM
POWER UNLOCK	Same wire, See DIAGRAM	See NOTE *3, See DAIGRAM
DOOR TRIGGER	See NOTE *4	IN EACH KICK PANEL
DOMELIGHT SUPERVISION	YELLOW/ORANGE (-), Requires Part #R30-H Relay	@ ANY UNDERDASH LIGHT
TRUNK RELEASE	ORANGE/PURPLE (-) See NOTE *5, Requires Part #R30-H Relay	IN DRIVERS KICK PANEL
SLIDING POWER DOOR	N/A
HORN	DARK GREEN/ORANGE (+)	@ HORN or IPM, Connector, C2 pin 35, See NOTE *6
TACH	ANY wire NOT RED/TAN or DARK GREEN/LIGHT GREEN	@ any FUEL-INJECTOR or IGNITION COIL
WAIT TO START LIGHT	N/A
BRAKE	WHITE/TAN (+) or WHITE/LIGHT GREEN (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	N/A
ANTI-THEFT	CHRYSLER'S SENTRY KEY, A TRANSPONDER SYSTEM	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 & *2 this vehicle requires a Special Circuit that requires (2) Relays and (2) Resistors, Starter #2 requires a (-)Negative thru a 180 Ohm Resistor and an extra relay part #R30-H and Accessory requires a (-)Negative thru a 610 Ohm Resistor and an extra relay part #R30-H, to connect this circuit up, See DIAGRAM NOTE *3 vehicles with MEMORY SEATS, have to go to the DRIVERS MEMORY MIRRO MODULE in the door to get this wire. The LOCK wire requires a (-)Negative thru 330 Ohm resistor and UNLOCK requires a (-)Negative thru a 100 Ohm resistor, some units require 2 extra relays part #R30-H, to connect. See DIAGRAM NOTE *4 the DRIVERS DOOR is a PURPLE (-) PIN 6, the PASSENGER DOOR is a PURPLE/WHITE (-) PIN 7, the DRIVERS REAR DOOR is a PURPLE/GRAY (-) PIN 4, and the PASSENGER REAR DOOR is a PURPLE/YELLOW (-) PIN 5, when connecting an ALARM SYSTEM, use all 4 DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM. NOTE *5 when testing the TRUNK/HATCH RELEASE wire, you must use the Key to open the REAR GLASS, this wire should then show a (-) Negative during testing. NOTE *6 the IPM (Integrated Power Module) is located on the DRIVERS FENDER, BEHIND THE BATTERY.