PART	COLOR	LOCATION
12 VOLT CONSTANT	RED (+) and LIGHT GREEN/PURPLE (+)	IGNITION SWITCH HARNESS
STARTER	DARK GREEN (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	PURPLE/ORANGE (+)	IGNITION SWITCH HARNESS
IGNITION 2	GRAY/YELLOW (+)	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	WHITE/LIGHT BLUE (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	WHITE/PURPLE (+)	IGNITION SWITCH HARNESS
KEYSENSE	N/A
PARKING LIGHTS ( - )	WHITE/BLACK (-)	@ LCM, GRAY 16-Pin Plug, Pin 13, See NOTE *2
PARKING LIGHTS ( + )	BROWN (+)	@ LCM, BLACK 16-Pin plug, pin 4, See NOTE *2
POWER LOCK	PINK/YELLOW (5 Wire Reverse Polarity) See NOTE *2	IN DRIVERS KICK PANEL @ DOOR HARNESS
POWER UNLOCK	PINK/LIGHT GREEN (5 Wire Reverse Polarity) See NOTE *2	IN DRIVERS KICK PANEL @ DOOR HARNESS
DOOR TRIGGER	DARK BLUE (-) and BLACK/ORANGE (-) Use both, See NOTE *3	@ LCM See NOTE *1 and *3
DOMELIGHT SUPERVISION	BLACK/LIGHT BLUE (+), Requires Part #R30-H Relay	@ LCM, BLACK 16-Pin plug, Pin 11, See NOTE *1
TRUNK RELEASE	PURPLE/YELLOW (5-Wire) See NOTE *4, Requires Part #R30-H Relay	IN DRIVERS KICK PANEL, in harness to rear of vehicle
SLIDING POWER DOOR	N/A
HORN	DARK BLUE (-)	@ LCM, GRAY 22-Pin plug, Pin 4, See NOTE *1
TACH	ANY wire NOT RED or WHITE/RED	@ any FUEL-INJECTOR or IGNITION COIL
WAIT TO START LIGHT	N/A
BRAKE	LIGHT GREEN/RED (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	N/A
ANTI-THEFT	FORD'S SECURILOCK ANTI-THEFT TRANSPONDER SYSTEM	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 the LCM (Lighting Control Module) is located to the RIGHT of the STEERING COLUMN NOTE *2 If vehicle is equipped with a FACTORY KEYLESS ENTRY System, then the vehicle has a Positive (+) Door Locking System, vehicles without FACTORY KEYLESS ENTRY, have a 5 Wire Reverse Polarity Door Locking System. Vehicles with the KEY PAD on the Door is considered to have KEYLESS ENTRY. NOTE *3 the DRIVERS DOOR is a DARK BLUE (-) in the GRAY 22-Pin plug, pin 11, the ORANGE/BLACK (-) covers all other doors and is in a GRAY 16-Pin plug, pin 11. When connecting to an Alarm System use BOTH DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM NOTE *4 the TRUNK RELEASE System on this vehicle uses a 5-Wire circuit and will require an extra relay part #R30-H, to connect, See DIAGRAM.