PART	COLOR	LOCATION
12 VOLT CONSTANT	LIGHT BLUE/RED (+)	IGNITION SWITCH HARNESS
STARTER	PINK/DARK GREEN (+)	IGNITION SWITCH HARNESS
STARTER 2	PURPLE/BROWN (-) See NOTE *1	IGNITION SWITCH HARNESS, See DIAGRAM
IGNITION 1	PINK/WHITE (+)	IGNITION SWITCH HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	PURPLE/BROWN (-) See NOTE *1	IGNITION SWITCH HARNESS, See DIAGRAM
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	WHITE/BROWN (-) See NOTE *4	@ HEADLIGHT SWITCH, See DIAGRAM
PARKING LIGHTS ( + )	WHITE/PURPLE (+)	IN PASSENGERS KICK PANEL
POWER LOCK	PURPLE/DARK GREEN (1-Wire Door Lock System) See NOTE *2	IN DRIVERS KICK PANEL, See DIAGRAM
POWER UNLOCK	Same wire, See DIAGRAM	See DIAGRAMS
DOOR TRIGGER	See NOTE *3	IN EACH KICK PANEL
DOMELIGHT SUPERVISION	YELLOW/WHITE (+) , Requires #R30-H Relay	INSTRUMENT CLUSTER, WHITE Plug, Pin 12
TRUNK RELEASE	PURPLE/TAN (-), Requires #R30-H Relay	@ TRUCK RELEASE SWITCH
SLIDING POWER DOOR	N/A
HORN	DARK GREEN/ORANGE (+)	@ HORNS UNDER HOOD
TACH	Any wire NOT BROWN /YELLOW	@ ANY IGNITION COIL or FUEL INJECTOR
WAIT TO START LIGHT	N/A
BRAKE	DARK GREEN/WHITE (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS with FACTORY REMOTE ONLY!!!
ANTI-THEFT	CHRYSLER'S SENTRY KEY, A TRANSPONDER SYSTEM	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 this vehicle requires a Special Circuit to Crank the vehicle and turn on the Accessories that requires (2) Relays and (2) Resistors, Starter #2 requires a (-)Negative thru a 180 Ohm Resistor and Accessory requires a (-)Negative thru a 610 Ohm Resistor to connect this circuit up See DIAGRAM NOTE *2 This vehicle uses a 1-Wire Door Locking System, a (-)Negative thru a 330 Ohm Resistor LOCKS and a (-)Negative thru a 100 Ohm Resistor UNLOCKS. 2 Extra Relays may be required, See DIAGRAM. NOTE *3 This vehicle uses 4 door triggers, the DRIVERS DOOR is a PURPLE (-) in a WHITE Plug, Pin 3, the PASSENGERS DOOR is a PURPLE/WHITE (-) in a WHITE Plug, Pin 3, the DRIVERS SIDE REAR DOOR is a PURPLE/GRAY (-) in a GRAY 26 Pin plug, Pin 10 and the PASSENGERS SIDE REAR DOOR is a PURPLE/YELLOW (-) in a GRAY 26 Pin Plug, Pin 9, when connecting to an ALARM SYSTEM use all 4 wires and DIODE ISOLATE. These wire are located in each kick panel or behind the instrument cluster. See DIAGRAM NOTE *4 to turn on the parking Lights on this vehicle will require a (-) Negative thru a 1670 Ohm and may also require a #R30-H Relay, to connect See DIAGRAM