Vehicle
Wiring Details for your
2005-2006 Pontiac Montana Sv6 Wiring Diagram |
Printer Friendly Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2005-2006 Pontiac Montana Sv6 . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
|
PART |
COLOR |
LOCATION |
12 VOLT
CONSTANT |
RED (+) or RED/BLACK (+) |
@ BATTERY or FUSE BOX |
STARTER |
YELLOW (+) |
@ IGNITION SWITCH HARNESS or BCM, C1, Pin 21 See NOTE #2 |
STARTER
2 |
N/A |
|
IGNITION
1 |
PINK (+) |
@ IGNITION SWITCH HARNESS or BCM, C1, PIN 22, See NOTE #2 |
IGNITION
2 |
N/A |
|
IGNITION
3 |
N/A |
|
ACCESSORY/HEATER
BLOWER 1 |
BROWN (+) |
@ IGNITION SWITCH HARNESS or BCM, C1, PIN 23, See NOTE #2 |
ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
KEYSENSE |
N/A |
|
PARKING
LIGHTS ( - ) |
BROWN/WHITE (-) |
@ BCM, C3 Pin 8, See NOTE #2 |
PARKING
LIGHTS ( + ) |
BROWN (+) |
@ FUSE BOX or PASSNEGER KICK in harness heading to rear of vehicle |
POWER LOCK |
ORANGE/BLACK to Pink/black(TYPE B) lock wire is orange/ black from switch but changes to a pink/black before the BCM |
@ BCM, C2 Pin 2, NOTE #2 |
POWER UNLOCK |
ORANGE/BLACK (TYPE B) |
@ BCM, C2 Pin 11, NOTE #2 |
DOOR TRIGGER |
See NOTE *2 |
@ BCM, C2, See NOTE #2 |
DOMELIGHT
SUPERVISION |
GRAY/BLACK (-) |
@ BCM, C1 Pin 43, See NOTE #2 |
TRUNK RELEASE |
N/A |
|
SLIDING
POWER DOOR |
N/A |
|
HORN |
TAN (-) |
@ BCM, C1, PIN 4, See NOTE #2 |
TACH |
Any wire NOT PINK (AC) |
@ any FUEL-INJECTOR |
WAIT TO
START LIGHT |
N/A |
|
BRAKE |
YELLOW (+) See NOTE #4 |
@ BCM, C2, PIN 43, See NOTE #2 |
FACTORY
ALARM DISARM |
PURPLE (-) |
@ BCM, C2 Pin 24, See NOTE #2 |
ANTI-THEFT |
PONTIAC'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 |
TRANSPONDER @ IGNITION SWITCH TUMBLER |
EXTRA
INFORMATION |
NOTE #1: This vehicle is equipped with PONTIAC'S TRANSPONDER ANTI-THEFT SYSTEM and will Require a Bypass Module for Remote Starting:
part # 791 BYPASS MODULE (Requires a spare Ignition key that starts the vehicle for Operation)
To order this part go to the SECURITY BYPASS MODULE Page on this website.
NOTE #2: the BCM (Body Control Module) is located to the LEFT of the STEERING COLUMN, C1 is a 52-pin BLACK Plug, C2 is a 52-pin BLACK Plug, and C3 is a 18-pin BLACK Plug.
NOTE #3: the DRIVERS DOOR is a GRAY/BLACK (-) PIN 26, the PASSENGER DOOR is a TAN/WHITE (-) PIN 17, the DRIVERS REAR DOOR is a LIGHT BLUE/BLACK (-) PIN 7 and the PASSENGER REAR DOOR is a LIGHT GREEN/BLACK (-) PIN 5. When connecting to an ALARM SYSTEM, use all (4) DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM
NOTE #4: the BRAKE wire on this vehicle must be tested with the IGNITION KEY turned ON.
|
|
|
|
|