Vehicle
Wiring Details for your
2005-2006 Ford Gt Wiring Diagram |
Printer Friendly Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2005-2006 Ford Gt . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
|
PART |
COLOR |
LOCATION |
12 VOLT
CONSTANT |
Connect to BATTERY ONLY |
|
STARTER |
PINK (+) |
@ IGNITION SWITCH HARNESS |
STARTER
2 |
N/A |
|
IGNITION
1 |
LIGHT GREEN/PURPLE (+) |
@ IGNITION SWITCH HARNESS |
IGNITION
2 |
N/A |
|
IGNITION
3 |
N/A |
|
ACCESSORY/HEATER
BLOWER 1 |
BLACK/LIGHT GREEN (+) |
@ IGNITION SWITCH HARNESS |
ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
KEYSENSE |
N/A |
|
PARKING
LIGHTS ( - ) |
WHITE/BLACK (-) |
@ HEADLIGHT SWITCH or SJB, Connector E, Pin 4, See NOTE #2 |
PARKING
LIGHTS ( + ) |
BROWN (+) |
@ SJB, Connector C, pin 19, See NOTE #2 |
POWER LOCK |
PINK/LIGHT BLUE (TYPE B) |
IN DRIVERS KICK PANEL or SJB, Connector D, pin 4, See NOTE #2 |
POWER UNLOCK |
PINK/WHITE (TYPE B) |
IN DRIVERS KICK PANEL or SJB, Connector D, pin 5, See NOTE #2 |
DOOR TRIGGER |
LIGHT GREEN/BLACK (-) and YELLOW/LIGHT GREEN (-) Use both, See NOTE #3 |
IN EACH KICK PANEL or the SJB, Connector D pins 21 and 20, See NOTE #2 |
DOMELIGHT
SUPERVISION |
PINK (-), (Requires Part #775 Relay) |
IN DRIVERS KICK PANEL or SJB, Connector C pin 28, See NOTE #2 |
TRUNK RELEASE |
RED (+) (HOOD) |
@ SJB, Connector C pin 16, See NOTE #2 |
SLIDING
POWER DOOR |
N/A |
|
HORN |
YELLOW/LIGHT GREEN (-) |
@ SJB, Connector A, pin 14, See NOTE #2 |
TACH |
BLACK/WHITE (AC) |
@ GCM, 16PIN PLUG, PIN A6, See NOTE #4 |
WAIT TO
START LIGHT |
N/A |
|
BRAKE |
RED/LIGHT GREEN (+) |
@ SWITCH ABOVE BRAKE PEDAL |
FACTORY
ALARM DISARM |
WHITE/PURPLE (-) |
@ SJB, Connector D, pin 2, See NOTE #1 |
ANTI-THEFT |
FORD'S ANTI-THEFT TRANSPONDER SYSTEM, See NOTE #1 |
@ IGNITION SWITCH TUMBLER |
EXTRA
INFORMATION |
NOTE #1: This vehicle MAY BE equipped with a Special Anti-theft key, to remote start you will
need a Bypass module 791,(use this module IF you have a extra ignition key to
place inside the 791 to remote start, if you do not have an extra key to use or wish
not to have a key placed inside this bypass module, we OFFER a KEYLESS INTERFACE
BYPASS MODULE that does not require a key to be placed inside the bypass module,
this is Part # PKALL or PKFM, either one will work, to order, go to the INTERFACE
BYPASS MODULE PAGE on this website.
NOTE #2: the SJB (Smart Junction Block) is the FUSE/RELAY BOX in the PASSENGER side
FOOTWELL.
NOTE #3: when connecting to an ALARM SYSTEM you must use both DOOR TRIGGER wires and
DIODE ISOLATE, to connect, See DIAGRAM
NOTE #4: the GCM (Guage Control Module) is located above the DATA LINK CONNECTOR under
the DRIVERS SIDE of the DASH.
|
|
|
|
|