NOTE #1: TOYOTA'S TRANSPONDER SYSTEM, Requires Bypass Module:
(For Remote Starting Only) Part #791 Bypass, Requires Extra Key for Operation,
(For Remote Starting Only) Part # PK-ALL Bypass. (No Extra Key Required for
Operation) 2-KEYS Required to Program Module.
To order please go to the SECURITY BYPASS MODULE Page or INTERFACE BYPASS
MODULE Page on this website.
NOTE #2: THE BECU (Body Electronic Control Unit) IS ATTACHED TO THE BACK OF THE FUSE
BOX, UNDER THE DRIVERS SIDEDASH.
NOTE #3: THE LOCK AND UNLOCK WIRES WILL ONLY TEST WHEN TURNING THE KEY IN THE
DRIVERS DOOR KEY CYLINDER.
NOTE #4: DRIVER DOOR TRIGGER IS RED/GREEN(-) AT THE BECU, BOTTOM PLUG, PIN 1
PASSENGER DOOR TRIGGER IS RED/GREEN(-) AT THE BECU, TOP PLUG, PIN 11.
REAR DOOR TRIGGERS ARE A RED/WHITE(-) AT THE BECU, BOTTOM OF THE
FUESBOX 20-PIN PLUG PIN 7. WHEN CONNECTING TO AN ALARM SYSTEM, USE
ALL 3 DOOR TRIGGER WIRES AND DIODE ISOLATE, TO CONNECT, SEE DIAGRAM.
NOTE #5: ON THE 2.4L ENGINE, THE TACH WIRE IS AT THE DATA LINK CONNECTOR UNDER
THE DRIVER SIDE DASH . ON THE 3.0L ENGINE, THE TACH WIRE IS AT THE ENGINE
CONTROL MODULE BEHIND THE GLOVEBOX, 31-PIN PLUG, PIN 5.
NOTE #6: this vehicle uses 2 STARTER/CRANK wires, when connecting to a Remote Starter you
must connect BOTH STARTER/CRANK wires to the STARTER/CRANK wire from the
Remote Starter. When installing a T-HARNESS you must make these connects in the
T-HARNESS to remote start.
NOTE #7: The (-) Negative Parking Light wire at the HEADLIGHT Switch is a RED (-) on most
vehicles, on some you may need to located a GREEN/RED (-) at this switch.
|