PART	COLOR	LOCATION
12 VOLT CONSTANT	WHITE/RED (+)	IGNITION SWITCH HARNESS
STARTER	BLACK/WHITE (+) See NOTE *5	IGNITION SWITCH HARNESS
STARTER 2	BLACK/YELLOW (+) See NOTE *5	IGNITION SWITCH HARNESS
IGNITION 1	BLACK/RED (+)	IGNITION SWITCH HARNESS
IGNITION 2	BLACK/YELLOW (+)	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	BLUE/RED (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	BLUE (-)	IGNITION SWITCH HARNESS
PARKING LIGHTS ( - )	RED (-) See NOTE *6	@ HEADLIGHT SWITCH or BECU, TOP Plug, Pin 8, See NOTE *1
PARKING LIGHTS ( + )	GREEN (+)	IN DRIVERS KICK PANEL or 13-PIN PLUG, BOTTOM of FUSEBOX
POWER LOCK	BLUE/YELLOW (Negative (-)) See NOTE *2	IN DRIVERS KICK PANEL or 20-PIN PLUG, BOTTOM of FUSE BOX
POWER UNLOCK	BLUE (Negative (-)) See NOTE *2 (REQUIRES DOUBLE PULSE)	IN DRIVERS KICK PANEL or BECU, TOP PLUG, PIN 22
DOOR TRIGGER	See NOTE *3	@ BECU, See NOTE *1
DOMELIGHT SUPERVISION	GREEN/RED (-), Requires Part #R30-H Relay	@ IGNITION KEY CYLINDER LIGHT
TRUNK RELEASE	WHITE/BLUE (-), Requires Part #R30-H Relay	IN DRIVERS KICK PANEL or BECU, BOTTOM PLUG, PIN 12, See NOTE *1
SLIDING POWER DOOR	N/A
HORN	GREEN/BLACK (-)	@ BOTTOM of FUSEBOX, 24-PIN PLUG
TACH	BLACK/ORANGE (-)	See NOTE *4
WAIT TO START LIGHT	N/A
BRAKE	GREEN/WHITE (+)	@ SWITCH ABOVE BRAKE PEDAL or BOTTOM of FUSEBOX, 24-PIN PLUG
FACTORY ALARM DISARM	DISARMS with KEYSENSE wire	@ IGNITION SWITCH HARNESS
ANTI-THEFT	TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES 791 BYPASS MODULE AND EXTRA IGNITION KEY	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 THE BECU (Body Electronic Control Unit) IS ATTACHED TO THE BACK OF THE FUSE BOX, UNDER THE DRIVERS SIDEDASH. NOTE *2 THE LOCK AND UNLOCK WIRES WILL ONLY TEST WHEN TURNING THE KEY IN THE DRIVERS DOOR KEY CYLINDER. NOTE *3 DRIVER DOOR TRIGGER IS RED/GREEN(-) AT THE BECU, BOTTOM PLUG, PIN 1 PASSENGER DOOR TRIGGER IS RED/GREEN(-) AT THE BECU, TOP PLUG, PIN 11. REAR DOOR TRIGGERS ARE A RED/WHITE(-) AT THE BECU, BOTTOM OF THE FUESBOX 20-PIN PLUG PIN 7. WHEN CONNECTING TO AN ALARM SYSTEM, USE ALL 3 DOOR TRIGGER WIRES AND DIODE ISOLATE, TO CONNECT, SEE DIAGRAM. NOTE *4 ON THE 2.4L ENGINE, THE TACH WIRE IS AT THE DATA LINK CONNECTOR UNDER THE DRIVER SIDE DASH . ON THE 3.0L ENGINE, THE TACH WIRE IS AT THE ENGINE CONTROL MODULE BEHIND THE GLOVEBOX, 31-PIN PLUG, PIN 5. NOTE *5 this vehicle uses 2 STARTER/CRANK wires, when connecting to a Remote Starter you must connect BOTH STARTER/CRANK wires to the STARTER/CRANK wire from the Remote Starter. When installing a T-HARNESS you must make these connects in the T-HARNESS to remote start. NOTE *6 The (-) Negative Parking Light wire at the HEADLIGHT Switch is a RED (-) on most vehicles, on some you may need to located a GREEN/RED (-) at this switch.