PART	COLOR	LOCATION
12 VOLT CONSTANT	BLACK (+) and BLACK/YELLOW (+)	IGNITION SWITCH HARNESS
STARTER	BLACK/BLUE (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	BLUE (+)	IGNITION SWITCH HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	BLACK/RED (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	BLACK/WHITE (+)	IGNITION SWITCH HARNESS
KEYSENSE	WHITE/BLUE (+)	IGNITION SWITCH HARNESS
PARKING LIGHTS ( - )	RED/WHITE (-)	@ HEADLIGHT SWITCH
PARKING LIGHTS ( + )	LIGHT GREEN/BLACK (+)	IN DRIVERS KICK PANEL, 14-Pin Plug
POWER LOCK	LIGHT GREEN (1-Wire Door Lock System) See NOTE *1	IN DRIVERS KICK PANEL or at DOOR LOCK MODULE, See NOTE *2
POWER UNLOCK	Same wire, See DIAGRAM	See DIAGRAMS
DOOR TRIGGER	GREEN/ORANGE (-)	IN DRIVERS KICK PANEL or at DOOR LOCK MODULE, See NOTE *2
DOMELIGHT SUPERVISION	YELLOW/BLACK (-), Requires Part #R30-H Relay	IN DRIVERS KICK PANEL or at DOOR LOCK MODULE, See NOTE *2
TRUNK RELEASE	YELLOW (-), Requires Part #R30-H Relay	@ TRUNK RELEASE SWITCH or at DOOR LOCK MODULE, See NOTE *2
SLIDING POWER DOOR	N/A
HORN	PURPLE/WHITE (-)	@ DOOR LOCK MODULE, See NOTE *2
TACH	See NOTE *3	@ Any IGNITION COIL
WAIT TO START LIGHT	N/A
BRAKE	GREEN/YELLOW (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	Disarms with KEYSENSE Wire	IGNITION SWITCH HARNESS
ANTI-THEFT	MAZDA'S TRANSPONDER ANTI-THEFT SYSTEM, Requires 791 Bypass Module and extra Ignition Key	@ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 to LOCK requires a (-)Negative thru a 1000 Ohm Resistor, to UNLOCK requires a Straight (-)Negative. Some units will also require 2 extra Relays part #R30-H, to connect, See DIAGRAMS NOTE *2 the DOOR LOCK MODULE is located ABOVE the PASSENGER KICK PANEL. NOTE *3 on the 4-Cylinder Engine, use any wire that is NOT BLACK/WHITE. On the 6-Cylinder Engine, use any wire that does NOT have a GREEN STRIPE.