PART	COLOR	LOCATION
12 VOLT CONSTANT	Connect to BATTERY ONLY	IGNITION SWITCH HARNESS
STARTER	YELLOW (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	PINK (+)	IGNITION SWITCH HARNESS
IGNITION 2	WHITE (+)	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	ORANGE (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	BROWN (+) Not Required for Remote Start	IGNITION SWITCH HARNESS
KEYSENSE	N/A
PARKING LIGHTS ( - )	BROWN/WHITE (-)	@ DIM Module, LIGHT BLUE Plug, Pin B3 See NOTE *2
PARKING LIGHTS ( + )	PURPLE (+) and BROWN/WHITE (+) Use both, See NOTE *1	@ FUSE BOX under REAR SEAT, GRAY Plug
POWER LOCK	RED/BLACK (Negative (-))	@ DOOR LOCK SWITCH in Drivers door
POWER UNLOCK	ORANGE/BLACK (Negative (-))	@ DOOR LOCK SWITCH in Drivers door
DOOR TRIGGER	See NOTE * 3	@ EACH DOOR MODULE in EACH DOOR
DOMELIGHT SUPERVISION	GRAY/BLACK (-)	@ RIM Module GRAY Plug pin A10 See NOTE *4
TRUNK RELEASE	LIGHT BLUE (-)	@ RIM Module, GRAY Plug, pin B4 See NOTE *4
SLIDING POWER DOOR	N/A
HORN	BLACK (-)	@ DIM Module, PINK Plug, pin A6 See NOTE *2
TACH	WHITE	@ PCM, BLUE Plug, pin 23 See NOTE *5
WAIT TO START LIGHT	N/A
BRAKE	WHITE (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	LIGHT GREEN (-)	@ DRIVERS DOOR MODULE in DRIVERS DOOR, GRAY Plug Pin B7
ANTI-THEFT	GM's PASSKEY 3 (PK3 on Steel Shaft of Ignition Key) TRANSPONDER SYSTEM	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 the PARKING LIGHTS on this vehicle use a 2 wire circuit, to connect will require 2 extra Relays part #R30-H, to connect See DIAGRAM. NOTE *2 the DIM Module is located BEHIND the GLOVE BOX NOTE *3 the DRIVERS DOOR is a GRAY/BLACK (-) the PASSENGER DOOR is a BLACK/WHITE (-) the DRIVERS REAR DOOR is the LIGHT BLUE/BLACK (-) and the PASSENGERS REAR DOOR is a LIGHT GREEN/BLACK (-) When connecting to an Alarm System use all 4 wires and DIODE ISOLATE See DIAGRAM NOTE *4 the RIM Module is located BEHIND the PASSENGER SIDE REAR Seat back. NOTE *5 the PCM is located under the Air Cleaner