NOTE #1: This vehicle requires a Special Circuit Connection to power up the Hearter/Blower
Accessory circuit, and Starter/Cranking circuit, this will require an extra Relay Part
#775 and 180 Ohm resistor. to connect, See DIAGRAM. There is a INTERFACE BYPASS
MODULE available that will NOT Require Resistors and Relays for the STARTER and
DOOR LOCKS it is PART # DB-ALL or XK09 it will do all you need with nothing extra, to
order go to the INTERFACE BYPASS MODULE Page on this website.
NOTE #2: This vehicle requires a Special Circuit Connection to power up the PARKING LIGHTS, it
will require an extra Relay part #775 and a (-)Negative thru a 920 Ohm Resistor, to
connect. See DIAGRAM. To see the wire and location, See the PICTURE Below
NOTE #3: This vehicle uses a Special 1-Wire Door Lock Circuit that requires extra parts. To
LOCK requires a (-)Negative thru a 1800 Ohm Resistor and to UNLOCK requires a
(-)Negative thru a 750 Ohm Resistor, some units will also require 2 extra relays part
#775 See DIAGRAM. To see the wire and location, you can do the DOOR LOCKS on
this vehicle with NOTHING EXTRA NEEDED Part #XK09, to order go to the INTERFACE
BYPASS MODULE Page on this website.
On base model vehicles, the PURPLE/LIGHT BLUE (DOOR LOCK/UNLOCK wire) is not in
the BLACK 20-PIN Plug at the DOOR SWITCH ASSEMBLY on the Drivers Door, you will
need to ADD this wire to the Pin location in the BLACK Plug at this Door Switch Assembly
in a BLACK 20-Pin Plug. The location is PIN 13, in the 20-PIN BLACK Plug. The open pin
13 is between Pin 12, an ORANGE/TAN wire and Pin 14, a LIGHT BLUE/WHITE wire in this
BLACK Plug. For a Picture see it Below.
NOTE #4: This vehicle uses 4 door trigger wires, the DRIVERS DOOR is a PURPLE (-) in the
DRIVERS DOOR at the DRIVERS DOOR SWITCH ASSEMBLY attached to the Drivers
Door Panel, the PASSENGER DOOR is a PURPLE/WHITE (-) in the passenger door at
the PASSENGER DOOR SWITCH ASSEMBLY, the DRIVERS REAR DOOR is a
PURPLE/GRAY (-) at the BCM, Plug C2, Pin 8 and the PASSENGER REAR DOOR is a
PURPLE/YELLOW (-) at the BCM, Plug, C3, Pin 5. When connecting to an ALARM
SYSTEM use all 4 wires and DIODE ISOLATE, See DIAGRAM, for the location of the
wires see the Pictures below.
NOTE #5: The BCM (Body Control Module) is located on the DRIVERS SIDE FIREWALL under the
DASH. See PICTURE Below
NOTE #6: If this wire is for the POWER LIFTGATE to operate, send a (-) Negative thru a 4700
Ohm Resistor to operate.
|