PART	COLOR	LOCATION
12 VOLT CONSTANT	WHITE/RED (+)	IGNITION SWITCH HARNESS
STARTER	BLACK/WHITE (+)	IGNITION SWITCH HARNESS
STARTER 2	BLACK/YELLOW (+)	IGNITION SWITCH HARNESS
IGNITION 1	RED/BLACK (+) or BLACK/RED (+)	IGNITION SWITCH HARNESS
IGNITION 2	BLACK/YELLOW (+)	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	BLUE/RED (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	BLUE (-)	IGNITION SWITCH HARNESS
PARKING LIGHTS ( - )	RED (-)	@ HEADLIGHT SWITCH
PARKING LIGHTS ( + )	GREEN (+)	@ BOTTOM of FUSE BOX, 12-PIN Plug, Pin 8
POWER LOCK	LIGHT GREEN or BLUE/YELLOW (Negative (-)) See NOTE *1	@ 20-PIN PLUG, DRIVER KICK PANEL TYPE (B)
POWER UNLOCK	BLUE (Negative (-)) (Requires Double Pulse) See NOTE *1	@ 20-PIN PLUG, DRIVER KICK PANEL TYPE (B)
DOOR TRIGGER	See NOTE *2	IN DRIVERS KICK PANEL and PASSENGER KICK PANEL
DOMELIGHT SUPERVISION	GREEN/RED (-), Requires Part #R30-H Relay	@ RIGHT SIDE of FUSEBOX, 12-PIN PLUG, PIN 5
TRUNK RELEASE	WHITE/BLUE or WHITE (5-Wire) See NOTE *3, Requires Part #R30-H Relay	IN DRIVER KICK PANEL, 17-PIN PLUG, PIN 3
SLIDING POWER DOOR	N/A
HORN	GREEN/BLACK (-)	@ STEERING COLUMN HARNESS
TACH	BLACK/ORANGE (-)	@ ECM, See NOTE *4
WAIT TO START LIGHT	N/A
BRAKE	GREEN/WHITE (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS with KEYSENSE wire, See NOTE *5	@ IGNITION SWITCH HARNESS
ANTI-THEFT	TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES 791 BYPASS MODULE AND EXTRA IGNITION KEY	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 when testing the LOCK and UNLOCK wires, test while turning the KEY in the DRIVERS DOOR KEY CYLINDER. NOTE *2 the DRIVERS DOOR is a RED/GREEN (-) in the DRIVERS KICK PANEL, 17-PIN Plug, Pin 11, the PASSENGER DOOR is in the PASSENGER KICK, the wire is in a 12-PIN plug, Pin 7, on the Convertible it is in a 17pin plug, pin 17. When connecting to an ALARM SYSTEM, use both DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM NOTE *3 this vehicle uses a 5-wire TRUNK/HATCH Release System that requires an extra Relay Part #R30-H, to connect, See DIAGRAM NOTE *4 the ECM (Engine Control Module) is located BEHIND the GLOVEBOX, on the 4-Cylinder, the tach wire is also located in the DATA LIK Connector, Pin 9, under the DRIVERS side of the DASH. NOTE *5 THE KEYSENSE WIRE WILL DISARM THE VEHICLE WITHOUT UNLOCKING THE DOORS BY APPLYING A (-)NEGATIVE TO THIS WIRE DURING REMOTE STARTING.