PART	COLOR	LOCATION
12 VOLT CONSTANT	WHITE/RED (+)	IGNITION SWITCH HARNESS
STARTER	BLACK/YELLOW (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	BLACK (+)	IGNITION SWITCH HARNESS
IGNITION 2	BLACK/YELLOW (+)	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	PINK (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	BLUE/BLACK (-)	IGNITION SWITCH HARNESS
PARKING LIGHTS ( - )	GREEN/BLACK (-)	@HEADLIGHT SWITCH
PARKING LIGHTS ( + )	DO NOT USE!
POWER LOCK	LIGHT GREEN (Negative (-)) See NOTE *1	IN DRIVERS KICK PANEL, 18-PIN Plug
POWER UNLOCK	BLUE (Negative (-)) (Requires Double Pulse) See NOTE *1	IN DRIVERS KICK PANEL, 18-PIN Plug
DOOR TRIGGER	BLUE (-)	@ INTERIOR LIGHT SWITCH on DASH
DOMELIGHT SUPERVISION	RED/GREEN (-)	@ INTERIOR LIGHT SWITCH on DASH
TRUNK RELEASE	YELLOW/RED (-), Requires Part #R30-H Relay	@ BOTTOM LEFT of FUSEBOX, 22-PIN Plug
SLIDING POWER DOOR	YELLOW/GREEN (Left) (-) and PURPLE (Right) (-) See NOTE *4, Requires Part #R30-H Relay	@ BOTTOM LEFT of FUSEBOX, 22-PIN Plug
HORN	GREEN/BLACK (-)	@ STEERING COLUMN HARNESS
TACH	BLACK/ORANGE (-)	@ ECM, Connector E4, Pin 5, See NOTE *2
WAIT TO START LIGHT	N/A
BRAKE	GREEN/WHITE (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS with KEYSENSE wire, See NOTE *3	@ IGNITION SWITCH HARNESS
ANTI-THEFT	TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES 791 BYPASS MODULE AND EXTRA IGNITION KEY	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 you must test the LOCK and UNLOCK wires while turning the KEY in the DRIVERS SIDE DOOR KEY CYLINDER. They will not test when operating from the POWER DOOR LOCK SWITCH. NOTE *2 the ECM (Engine Control Module) is located BEHIND the GOLVEBOX. Connector E4 is the TOP Plug. NOTE *3 THE KEYSENSE WIRE WILL DISARM THE VEHICLE WITHOUT UNLOCKING THE DOORS BY APPLYING A (-)NEGATIVE TO THIS WIRE DURING REMOTE STARTING. NOTE *4 Both SLIDING DOOR can be operated by a (-)Negative to these wires, a Relay Part #R30-H will be required for each door function.