PART	COLOR	LOCATION
12 VOLT CONSTANT	Connect to BATTERY ONLY
STARTER	BLACK/WHITE (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	BLACK/RED (+)	IGNITION SWITCH HARNESS
IGNITION 2	BLUE/BLACK (+)	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	BLACK (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	RED/BLACK (-)	IGNITION SWITCH HARNESS
PARKING LIGHTS ( - )	GREEN/BLACK (-)	@ BECU,26-PIN PLUG, PIN 8, See NOTE *1
PARKING LIGHTS ( + )	GREEN (+)	@ BECU, 30-PIN PLUG, PIN 28, See NOTE *1
POWER LOCK	BLUE/WHITE (Negative (-)) See NOTE *2	@ 42-PIN PLUG, BOTTOM of FUSEBOX
POWER UNLOCK	GREEN/BLACK (Negative (-)) See NOTE *2	@ 42-PIN PLUG, BOTTOM of FUSEBOX
DOOR TRIGGER	See NOTE *3	@ BECU, 24-PIN PLUG, See NOTE *1
DOMELIGHT SUPERVISION	GREEN/WHITE (-), Requires Part #R30-H Relay	@ DRIVERS FUSEBOX, TOP LEFT, 20-PIN PLUG
TRUNK RELEASE	N/A
SLIDING POWER DOOR	N/A
HORN	GREEN/ORANGE (-)	@ DRIVERS FUSEBOX, TOP, 25-PIN PLUG
TACH	BLACK (-)	@ DATA LINK CONNECTOR, UNDER DRIVERS DASH
WAIT TO START LIGHT	N/A
BRAKE	GREEN/WHITE (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS with KEYSENSE wire	@ IGNITION SWITCH HARNESS
ANTI-THEFT	TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES 791 BYPASS MODULE AND EXTRA IGNITION KEY	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 THE BECU (Body Electronic Control Unit) IS ATTACHED TO THE BACK OF THE FUSEBOX IN THE DRIVERS KICK PANEL. NOTE *2 WHEN TESTING THE LOCK/UNLOCK WIRES, YOU MUST USE THE KEY IN THE PASSENGER DOOR KEY CYLINDER, THESE WIRES WILL NOT TEST WITH THE POWER DOOR LOCK SWITCH. NOTE *3 LEFT FRONT DOOR IS RED/YELLOW(-) IN PIN 23, RIGHT FRONT DOOR IS RED/BLACK(-) IN PIN 24, LEFT REAR DOOR IS RED/BLUE(-) IN PIN 11, RIGHT REAR DOOR IS RED/GREEN(-) IN PIN 12 . WHEN CONNECTING TO AN ALARM SYSTEM, USE ALL 4 DOOR TIRGGER WIRES AND DIODE ISOLATE, TO CONNECT, SEE DIAGRAM