PART	COLOR	LOCATION
12 VOLT CONSTANT	RED (+) (X2)	@ IGNITION SWITCH HARNESS
STARTER	BLACK/BLUE (+)	@ IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	GREEN (+)	@ IGNITION SWITCH HARNESS
IGNITION 2	PURPLE/BLACK (+)	@ IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	N/A
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	BLACK (-)	@ GMCU, BLUE Plug, Pin 27, See NOTE *1
PARKING LIGHTS ( + )	N/A
POWER LOCK	YELLOW/RED (Negative (-)) See NOTE *2	@ GMCU, BLUE Plug, Pin 44, See NOTE *1
POWER UNLOCK	YELLOW/BROWN (Negative (-)) See NOTE *2	@ GMCU, BLUE Plug, Pin 42, See NOTE *1
DOOR TRIGGER	See NOTE *3	@ GMCU, BLACK Plug, Pins 22 and 42, See NOTE *1
DOMELIGHT SUPERVISION	BROWN/YELLOW (-)	@ GMCU, BLACK Plug, Pin 7, See NOTE *1
TRUNK RELEASE	GRAY/BROWN (-)	@ GMCU, BLACK Plug, Pin 24, See NOTE *1
SLIDING POWER DOOR	N/A
HORN	BROWN/YELLOW (-)	@ HORN SWITCH
TACH	Any wire NOT: RED or RED STRIPPED	@ Any IGNITION COIL or FUEL-INJECTOR
WAIT TO START LIGHT	N/A
BRAKE	BLUE/RED (+) or BROWN/GRAY (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	WHITE/BLACK (-) See NOTE *4	@ GMCU, BLACK Plug, Pin 3, See NOTE *1
ANTI-THEFT	MINI'S TRANSPONDER ANTI-THEFT System	@ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 The GMCU Module is located on the PASSENGER KICK PANEL. NOTE *2 TEST the LOCK and UNLOCK wires on the vehcile while pressing the Door Lock Switch on the Dash. NOTE *3 The DRIVERS DOOR Trigger wire is a BROWN/GRAY/YELLOW (-) and the PASSENGER DOOR Trigger is a BROWN/GRAY/YELLOW (-). When connecting to an Alarm System, use both wires and DIODE ISOLATE, See DIAGRAM NOTE *4 TEST the FACTORY DISARM wire while Turning the Key in the Drivers Door Key Cylinder.