Vehicle
Wiring Details for your
2004-2007 Ford Focus Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2004-2007 Ford Focus . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED (+) |
@ IGNITION SWITCH HARNESS |
| STARTER |
GRAY/BLACK (+) |
@ IGNITION SWITCH HARNESS |
| STARTER
2 |
N/A |
|
| IGNITION
1 |
GREEN/YELLOW (+) |
@ IGNITION SWITCH HARNESS |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
YELLOW (+) |
@ IGNITION SWITCH HARNESS |
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
RED/BLACK (-) |
@ IGNITION SWITCH HARNESS |
| PARKING
LIGHTS ( - ) |
N/A |
|
| PARKING
LIGHTS ( + ) |
ORANGE/YELLOW (+) |
@ HEADLIGHT SWITCH or GEM, TAN Plug, Pin 14, See NOTE #5 |
| POWER LOCK |
BLACK/RED (TYPE B) |
IN DRIVERS KICK PANEL or GEM, GRAY Plug, Pin 15, See NOTE #5 |
| POWER UNLOCK |
BLACK/YELLOW (TYPE B) |
IN DRIVERS KICK PANEL or GRAY Plug, Pin 21, See NOTE #5 |
| DOOR TRIGGER |
See NOTE #2 |
@ GEM, See NOTE #5 |
| DOMELIGHT
SUPERVISION |
BLACK/BLUE (-), (Requires Part #775 Relay) |
@ GEM, GREY Plug, Pin 3, See NOTE #5 |
| TRUNK RELEASE |
BLACK/YELLOW (-), (Requires Part #775 Relay) |
@ TRUNK RELEASE SWITCH |
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
BLACK/BLUE (-) or BLACK/GREEN (-) |
@ STEERING COLUMN HARNESS or GEM, BROWN Plug, Pin 14, See NOTE #5 |
| TACH |
BLACK/GREEN or BLACK/ORANGE (AC) |
@ IGNITON COIL |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
GREEN/RED (+) |
@ GEM, TAN Plug, Pin 9, See NOTE #5 |
| FACTORY
ALARM DISARM |
BLACK/WHITE (-) |
@ GEM, GRAY Plug, Pin 14, See NOTE #5 |
| ANTI-THEFT |
FORD'S ANTI-THEFT TRANSPONDER SYSTEM, SEE NOTE #1 |
@ IGNITION SWITCH TUMBLER |
| EXTRA
INFORMATION |
| NOTE #1: This vehicle MAY BE equipped with a Special Anti-theft key, to remote start you will
need a Bypass module 791,(use this module IF you have a extra ignition key to
place inside the 791 to remote start, if you do not have an extra key to use or wish
not to have a key placed inside this bypass module, we OFFER a KEYLESS INTERFACE
BYPASS MODULE that does not require a key to be placed inside the bypass module,
this is Part # PKALL or PKFM, either one will work, to order, go to the INTERFACE
BYPASS MODULE PAGE on this website.
NOTE #2: This vehicle has (4) door trigger wires, the DRIVERS DOOR is a YELLOW/BLACK (-)
in a TAN Plug, Pin 22, the PASSENGER DOOR is a BLACK/BLUE (-) TAN Plug, Pin 21,
the DRIVERS REAR DOOR is a BLACK/ORANGE (-) in a WHITE Plug, Pin 15 and the
PASSENGER REAR DOOR is a BLACK/GREEN (-) in a GRAY Plug, Pin 15. When
connecting to an ALARM SYSTEM use all 4 DOOR TRIGGER wires and DIODE ISOLATE,
to connect, See DIAGRAM
NOTE #3: The IGNITION SWITCH MUST be turned on before the Brake wire will test properly.
NOTE #4: The FACTORY KEYLESS ENTRY Module (if so equipped) is located behind and to
the right of the GLOVE BOX.
NOTE #5: The GEM (Generic Electronic Module) is located above the PASSENGER KICK PANEL.
|
|
|
|
|
|
