PART	COLOR	LOCATION
12 VOLT CONSTANT	LIGHT GREEN/PURPLE (+)	IGNITION SWITCH HARNESS
STARTER	RED/LIGHT BLUE (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	DARK BLUE/LIGHT GREEN (+)	IGNITION SWITCH HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	BLACK/LIGHT GREEN (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	BROWN (+)	@ HEADLIGHT SWITCH or BCM, BLUE Plug, Pin 6, See NOTE *1
POWER LOCK	PINK/YELLOW (Negative (-))	IN DRIVERS DOOR BOOT or @ BCM, GREEN Plug, Pin 9, See NOTE *1
POWER UNLOCK	PINK/LIGHT GREEN (Negative (-))	IN DRIVERS DOOR BOOT or @ BCM, GREEN Plug, Pin 1, See NOTE *1
DOOR TRIGGER	BLACK/YELLOW (-) and BLACK/PINK (-) Use both, See NOTE *2	IN DRIVERS KICK PANEL, GRAY Plug, Pins 22 and 23
DOMELIGHT SUPERVISION	BLACK/LIGHT BLUE (+), Requires Part #R30-H Relay	IN DRIVERS KICK PANEL, GRAY Plug, Pin 6
TRUNK RELEASE	N/A
SLIDING POWER DOOR	N/A
HORN	DARK BLUE (-)	@ STEERING COLUMN HARNESS or BCM, BLUE Plug, Pin 12, See NOTE *1
TACH	Any wire that is NOT RED or RED/LIGHT GREEN	@ IGNITON COIL or FUEL INJECTORS
WAIT TO START LIGHT	N/A
BRAKE	LIGHT GREEN (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	N/A
ANTI-THEFT	FORD'S SECURILOCK ANTI-THEFT TRANSPONDER SYSTEM	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 The BCM (Body Control Module) is located on the DRIVERS SIDE REAR CAB WALL. NOTE *2 Use the above wires on vehicles without Factory Keyless Entry, with Factory Keyless, the wires are at the BCM, DRIVERS DOOR BLACK/YELLOW (-) Pin 4, PASSENGER DOOR, BLACK/PINK (-) Pin 5, the DRIVERS SIDE REAR DOOR is a BLACK/LIGHT BLUE (-) Pin 12 and the PASSENGER REAR DOOR is a BLACK/WHITE (-) Pin 13. When connecting to an ALARM SYSTEM, use all 4 DOOR TRIGGER wires and DIODE ISOLATE. to connect, See DIAGRAM