Vehicle
Wiring Details for your
2004 -2007 Dodge Caravan Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2004 -2007 Dodge Caravan . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
Connect to BATTERY ONLY |
|
| STARTER |
YELLOW (+) (20 Gauge) |
IGNITION SWITCH HARNESS, BLACK Plug |
| STARTER
2 |
PURPLE/BROWN (-) (20 Gauge) See NOTE * 1 |
IGNITION SWITCH HARNESS, BLACK Plug, See DIAGRAM |
| IGNITION
1 |
PINK/WHITE (+) (20 Gauge) (2 Wires, use either wire) |
IGNITION SWITCH HARNESS, BLACK Plug |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
WHITE/BROWN (-) See NOTE *2 |
@ HEADLIGHT SWITCH, BLACK Plug, See DIAGRAM |
| PARKING
LIGHTS ( + ) |
DO NOT USE! |
|
| POWER LOCK |
PURPLE/GREEN (1-Wire Door Lock System) See NOTE *3 |
@ BCM, BLACK plug, Plug 2, See DIAGRAM |
| POWER UNLOCK |
Same wire, See DIAGRAM |
See DIAGRAM |
| DOOR TRIGGER |
See NOTE *4 |
@ BCM, BLACK Plug, Plug 2, See NOTE *5 |
| DOMELIGHT
SUPERVISION |
YELLOW/BROWN (+) |
@ BCM, BLACK Plug, Plug 2, See NOTE *5 |
| TRUNK RELEASE |
PURPLE/TAN (-) See NOTE *6 |
@ BCM, GREEN Connector , Pin 6, See DIAGRAM |
| SLIDING
POWER DOOR |
PURPLE/BLUE (-) See NOTE *7 |
@ BCM, BLACK Plug, Plug 2, See DIAGRAM |
| HORN |
GREEN/PURPLE (-) |
@ STEERING COLUMN HARNESS, WHITE Plug |
| TACH |
See NOTE *8 |
@ COIL PACK |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
WHITE/TAN (+) |
@ SWITCH ABOVE BRAKE PEDAL |
| FACTORY
ALARM DISARM |
DISARMS with FACTORY REMOTE ONLY |
|
| ANTI-THEFT |
CHRYSLER'S SENTRY KEY, A TRANSPONDER SYSTEM |
TRANSPONDER @ IGNITION SWITCH TUMBLER |
| EXTRA
INFORMATION |
| NOTE *1 To Remote Start this vehicle and turn on the AC/Heater, will require an extra relay part #R30-H and a (-)Negative thru a 180 Ohm Resistor, THIS MUST BE INSTALLED to operate in Remote Start mode, to connect, See DIAGRAM.
NOTE *2 To turn on the PARKING LIGHTS requires a (-)Negative thru a 2000 Ohm resistor and an extra relay part #R30-H to connect, See DIAGRAM
NOTE *3 This vehicle uses a 1-Wire Door Locking System requiring a (-)Negative thru a 5200 Ohm Resistor for LOCK, and a (-)Negative thru a 2000 Ohm Resistor for UNLOCK, some units will also require 2 extra relays part #R30-H to connect, See DIAGRAMS
NOTE *4 This vehicle uses 4 door pin trigger wires, the DRIVERS DOOR is a PURPLE (-) at PIN 6, the PASSENGERS DOOR is a PURPLE/WHITE (-) PIN 7, the DRIVERS SIDE SLIDING DOOR is a PURPLE/GRAY, PIN 8 and the PASSENGER SIDE SLIDING DOOR is a PURPLE/YELLOW, PIN 5. When connecting to an ALARM SYSTEM use all 4 wires and DIODE ISOLATE. See DIAGRAM
NOTE *5 The BCM (Body Control Module is located in the DRIVERS KICK PANEL, near the PARKING BRAKE. The BCM has 5 Plugs, (1) 6-Pin Plug, and (4) 34-Pin PLugs.
NOTE *6 The Rear Hatch Pop is a (-) Negative thru a 1500 Ohm Resistor and requires an extra relay part #R30-H to connect, See DIAGRAM
NOTE *7 The SLIDING DOORS require a (-)Negative thru a 1500 Ohm Resistor for the DRIVERS SIDE and a (-)Negative thru a 2700 Ohm Resistor for the PASSANGER SIDE and 2 extra relays part #R30-H for each door, See DIAGRAM.
NOTE *8 The TACH wire on the 2.4L is BLUE/GREEN or BLUE/TAN. On the 3.3L and 3.8L use the BLUE/GREEN, BLUE/TAN or BLUE/ORANGE
|
|
|
|
|
|
