PART	COLOR	LOCATION
12 VOLT CONSTANT	Connect to BATTERY ONLY
STARTER	YELLOW (+)	IGNITION SWITCH HARNESS
STARTER 2	PURPLE/BROWN (-) See NOTE *1	IGNITION SWITCH HARNESS
IGNITION 1	PINK/GRAY (+)	IGNITION SWITCH HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	N/A
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	BROWN/WHITE (-) See NOTE *2	@ HEADLIGHT SWITCH, See DIAGRAM
PARKING LIGHTS ( + )	DO NOT USE!
POWER LOCK	PURPLE/LIGHT BLUE (1-Wire Door Lock System) See NOTE *3	@ DRIVERS DOOR SWITCH ASSEMBLY, on the DRIVERS DOOR PANEL, See DIAGRAM
POWER UNLOCK	Same wire, See DIAGRAM	See DAIGRAM
DOOR TRIGGER	See NOTE *4	@ DRIVERS DOOR SWITCH ASSEMBLY, on the DRIVERS DOOR PANEL, See NOTE *4
DOMELIGHT SUPERVISION	TURNS ON with UNLOCK
TRUNK RELEASE	PURPLE/TAN (-) See NOTE *6	@ BCM, Plug C3, Pin 7, See NOTE *5
SLIDING POWER DOOR	N/A
HORN	DARK GREEN/PURPLE (-)	@ STEERING COLUMN HARNESS
TACH	ANY wire that is NOT BROWN/WHITE	@ Any COIL or FUEL INJECTOR
WAIT TO START LIGHT	N/A
BRAKE	WHITE/DARK GREEN (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS WITH UNLOCK
ANTI-THEFT	CHRYSLER'S SENTRY KEY, A TRANSPONDER SYSTEM	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 This vehicle requires a Special Circuit Connection to power up the Hearter/Blower Accessory circuit, and Starter/Cranking circuit, this will require an extra Relay Part #R30-H and 180 Ohm resistor. to connect, See DIAGRAM. For the wires and Identification, See the PICTURE Below NOTE *2 This vehicle requires a Special Circuit Connection to power up the PARKING LIGHTS, it will require an extra Relay part #R30-H and a (-)Negative thru a 920 Ohm Resistor, to connect. See DAIGRAM. To see the wire and location, See the PICTURE Below NOTE *3 This vehicle uses a Special 1-Wire Door Lock Circuit that requires extra parts. To LOCK requires a (-)Negative thru a 1800 Ohm Resistor and to UNLOCK requires a (-)Negative thru a 750 Ohm Resistor, some units will also require 2 extra relays part #R30-H See DIAGRAM. To see the wire and location, See the PICTURES Below SPECIAL NOTE * On base model vehicles, the PURPLE/LIGHT BLUE (DOOR LOCK/UNLOCK wire) is not in the BLACK 20-PIN Plug at the DOOR SWITCH ASSEMBLY on the Drivers Door, you will need to ADD this wire to the Pin location in the BLACK Plug at this Door Switch Assembly in a BLACK 20-Pin Plug. The location is PIN 13, in the 20-PIN BLACK Plug. The open pin 13 is between Pin 12, an ORANGE/TAN wire and Pin 14, a LIGHT BLUE/WHITE wire in this BLACK Plug. For a Picture see it Below. NOTE *4 This vehicle uses 4 door trigger wires, the DRIVERS DOOR is a PURPLE (-) in the DRIVERS DOOR at the DRIVERS DOOR SWITCH ASSEMBLY attached to the Drivers Door Panel, the PASSENGER DOOR is a PURPLE/WHITE (-) in the passenger door at the PASSENGER DOOR SWITCH ASSEMBLY, the DRIVERS REAR DOOR is a PURPLE/GRAY (-) at the BCM, Plug C2, Pin 8 and the PASSENGER REAR DOOR is a PURPLE/YELLOW (-) at the BCM, Plug, C3, Pin 5. When connecting to an ALARM SYSTEM use all 4 wires and DIODE ISOLATE, See DIAGRAM, for the location of the wires see the Pictures below. NOTE *5 The BCM (Body Control Module) is located on the DRIVERS SIDE FIREWALL under the DASH. See PICTURE Below NOTE *6 If this wire is for the POWER LIFTGATE to operate, send a (-) Negative thru a 4700 Ohm Resistor to operate.