PART	COLOR	LOCATION
12 VOLT CONSTANT	RED/BLACK (+)	@ BCM, C3, Pin D1, See NOTE *6
STARTER	YELLOW (+) (NOT REQUIRED FOR REMOTE STARTING) See NOTE *5	@ PCM, BLUE Plug, Pin 48 or 23, See NOTE *7
STARTER 2	N/A
IGNITION 1	PINK (+)	@ IGNITION HARNESS or BCM, C4, PIN D3, See NOTE *6
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	BROWN (+) See NOTE *3 See DIAGRAM	@ IGNITION HARNESS or BCM, C4, PIN C8, See NOTE *3 and NOTE *6
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	BROWN/WHITE (-)	@ BCM, Plug C2, Pin 5, See NOTE *6
PARKING LIGHTS ( + )	BROWN (+)	@ BCM. Plug C3, Pin A7, See NOTE *6
POWER LOCK	WHITE (1-Wire System) See NOTE *1	@ BCM. Plug C1, Pin 66, See NOTE *6
POWER UNLOCK	Same wire, See DIAGRAM	See DIAGRAMS
DOOR TRIGGER	See NOTE *2	See DIAGRAMS
DOMELIGHT SUPERVISION	GRAY (-)	@ BCM, Plug C3, Pin A10, See NOTE *6
TRUNK RELEASE	WHITE/BLACK (-)	@ BCM, Plug C1, Pin 4, See NOTE *6
SLIDING POWER DOOR	N/A
HORN	TAN ( - )	@ BCM, Plug C2, Pin 14, See NOTE *6
TACH	See NOTE *4
WAIT TO START LIGHT	N/A
BRAKE	WHITE (+)	@ SWITCH ABOVE BRAKE PEDAL or BCM, C1 PIN 42
FACTORY ALARM DISARM	N/A
ANTI-THEFT	GM's PASSKEY 3 (PK3 on Steel Shaft of Ignition Key) TRANSPONDER SYSTEM	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 This vehicle uses a (1) WIRE door locking system, a Straight (-)Negative will LOCK the doors, a (-)Negative thru a 1500 ohm Resistor will UNLOCK the doors. All doors must be closed for this to function properly. See DIAGRAMS. NOTE *2 This vehicle has 4 door pin triggers, for the DRIVERS door use the GREY/BLACK (-) Pin 51, for the PASSENGER door, use the TAN/WHITE (-) Pin 72, DRIVERS REAR door LIGHT BLUE/BLACK (-) Pin 54, PASSENGER REAR door, LIGHT GREEN/BLACK (-) Pin 53, use all 4 and DIODE ISOLATE when connecting to an ALARM SYSTEM. See DIAGRAM NOTE *3 if the Remote Starter Module DOES NOT DROP the voltage out to the ACCESSORY wire during cranking it will be necessary to add a R30-H Relay See DIAGRAM, The ACCESSORY wire from the Remote Starter (WHITE/BLACK or BROWN) is not used on this vehicle. NOTE *4 On the 2.2L engine use the WHITE or ORANGE for the TACH WIRE, on the 3.5L engine use the PURPLE, ORANGE/WHITE or LIGHT BLUE. NOTE *5 Starter is not required for REMOTE STARTING, this vehicle will crank the engine when it see IGNITION POWER and ACCESSORY loses voltage. NOTE *6 the BCM (Body Control Module) is part of the FUSE/RELAY BOX on the front passenger side of the Center Console. the connectors are: C1, 72-PIN GRAY PLUG, C2, 72-PIN GRAY PLUG, C3, 42-PIN RED PLUG, and C4, 68-PIN LIGHT GRAY PLUG NOTE *7 the PCM (Powertrain Control Module) is located in FRONT of the BATTERY on the DRIVERS SIDE of the VEHICLE.